[RFC PATCH 2/8] media: v4l: Add 10-bit RGBIr formats

[Rishikesh Donadkar]

On 26/09/26 20:00, Sakari Ailus wrote:
> Hi Rishikesh,
> 
> On Fri, Sep 25, 2026 at 06:59:55PM +0530, Rishikesh Donadkar wrote:
>> From: Jai Luthra <j-luthra at ti.com>
>>
>> Some camera sensors now use an expanded CFA pattern to capture near-IR
>> light along with the visible spectrum (R,G,B). This allows capturing
>> light in both low-light and day-light scenarios using the same sensor.
>>
>> Instead of having a 2x2 repetition of B,G,R like in older bayer formats,
>> here we have a 4x4 repetition of B,G,R,Ir where the number of G pixels
>> are the same, but half the B and R pixels are replaced with Ir. Thus
>> instead of having 4 total phases, we now have 8 total phases or
>> re-arrangements of this pattern.
>>
>> Co-developed-by: Rahul T R <r-ravikumar at ti.com>
>> Signed-off-by: Rahul T R <r-ravikumar at ti.com>
>> Signed-off-by: Jai Luthra <j-luthra at ti.com>
>> Co-developed-by: Rishikesh Donadkar <r-donadkar at ti.com>
>> Signed-off-by: Rishikesh Donadkar <r-donadkar at ti.com>
> 
> I think we need to use the common raw mbus and pixel formats for the
> patterns that have IR pixels. See
> <URL:https://git.linuxtv.org/sailus/media_tree.git/log/?h=metadata>.

Sure, I will use the RAW mbus pixel formats.

> 
> That's mostly pending on userspace support now.
> 
> Can the sensor output Bayer pattern as well?

No, the sensor give only gives out RGB+Ir where the CFA is a 4x4 
repetition of B,G,R and Ir.

Rishikesh
>