[PATCH v5 2/3] arm64: dts: nuvoton: ma35d1: add USB controllers and dual-port PHY node

[Joey Lu]

Jacky Huang 於 2026/9/19 下午 01:49 寫道:
>> Add the USB subsystem nodes for the MA35D1 SoC and boards:
>>
>>    - usb_phy: standalone PHY node with #phy-cells = <1>, covering both
>>      the OTG port (PHY0, index 0) and the host-only port (PHY1, index 
>> 1).
>>      Uses nuvoton,sys phandle and HUSBH0_GATE clock per the binding.
>>
>>    - usb (DWC2 gadget, USB0): phys = <&usb_phy 0>, dr_mode = peripheral.
>>    - ehci0/ohci0 (USB0 host): phys = <&usb_phy 0>, companion pairing.
>>    - ehci1/ohci1 (USB1 host): phys = <&usb_phy 1>.
>>
>> Board files (ma35d1-som-256m.dts, ma35d1-iot-512m.dts) add pinctrl for
>> VBUSVLD, PWREN and OVC signals and enable all USB nodes.
>>
>> Signed-off-by: Joey Lu <a0987203069 at gmail.com>
>> ---
>>   .../boot/dts/nuvoton/ma35d1-iot-512m.dts      | 36 ++++++++++
>>   .../boot/dts/nuvoton/ma35d1-som-256m.dts      | 36 ++++++++++
>>   arch/arm64/boot/dts/nuvoton/ma35d1.dtsi       | 65 +++++++++++++++++++
>>   3 files changed, 137 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/nuvoton/ma35d1-iot-512m.dts 
>> b/arch/arm64/boot/dts/nuvoton/ma35d1-iot-512m.dts
>> index 78534d613486..0a068abda6e0 100644
>> --- a/arch/arm64/boot/dts/nuvoton/ma35d1-iot-512m.dts
>> +++ b/arch/arm64/boot/dts/nuvoton/ma35d1-iot-512m.dts
>> @@ -97,6 +97,16 @@ pinctrl_uart14: uart14-pins {
>>                          power-source = <1>;
>>                  };
>>          };
>> +
>> +       hsusb {
>> +               pinctrl_hsusb: hsusb-pins {
>> +                       nuvoton,pins = <5 15 1>, /* VBUSVLD */
>> +                                      <11 12 9>, /* PWREN */
>> +                                      <11 13 9>; /* OVC */
>> +                       bias-disable;
>> +                       power-source = <1>;
>> +               };
>> +       };
>>   };
>>
>
> The outer pinctrl group node name does not match the MA35D1 pinctrl 
> binding. dt-validate reports:
>
>   'hsusb' does not match any of the regexes: '-grp$',
>   '^gpio@[0-9a-f]+$', '^pinctrl-[0-9]+$'
>
> Please rename it to "hsusb-grp" in both ma35d1-iot-512m.dts and 
> ma35d1-som-256m.dts.
>
> I tested this change locally. Both affected DTBs build and validate 
> cleanly after the rename.
>
>
> Best regards,
> Jacky Huang
Agreed, hsusb doesn't match the pinctrl node-name regex. I'll rename it 
to hsusb-grp in both
ma35d1-iot-512m.dts and ma35d1-som-256m.dts in the next revision.

Thanks.