[PATCH net-next v3 1/3] net: stmmac: sun8i: reset the MAC after PHY initialization

[Maxime Chevallier]

Hi,

On 9/17/26 19:55, James Hilliard wrote:
> The MAC software reset needs a running receive clock from the PHY.
> Resetting the MAC at the end of probe therefore fails when the PHY driver
> has not been loaded or its probe has deferred on a missing supplier. The
> failure removes the MAC and its MDIO bus, so loading the missing driver
> later cannot recover the interface without reprobing the MAC.
> 
> Perform the software reset in the DMA reset callback instead. The stmmac
> core calls it during hardware setup after attaching and initializing the
> PHY, and resumes a suspended PHY before reopening or resuming the MAC.
> Keep the existing register clearing after a successful reset and return
> reset errors through the normal hardware-setup error path.
> 
> Remove the unconditional reset from probe. Keep the separate H3 MDIO-mux
> reset after switching the mux and powering the selected PHY, since it is
> needed to latch the selected interface before MDIO accesses.
> 
> Signed-off-by: James Hilliard <james.hilliard1 at gmail.com>

Reviewed-by: Maxime Chevallier <maxime.chevallier at bootlin.com>

Maxime

> ---
>  drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c | 50 +++++++++++------------
>  1 file changed, 24 insertions(+), 26 deletions(-)
> 
> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
> index 48c52eb96233..4523a14f5e0c 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
> @@ -269,11 +269,32 @@ static const struct emac_variant emac_variant_h6 = {
>  #define SYSCON_ETCS_EXT_GMII	0x1
>  #define SYSCON_ETCS_INT_GMII	0x2
>  
> +static int sun8i_dwmac_reset(void __iomem *ioaddr)
> +{
> +	u32 v;
> +
> +	v = readl(ioaddr + EMAC_BASIC_CTL1);
> +	writel(v | 0x01, ioaddr + EMAC_BASIC_CTL1);
> +
> +	/* The timeout was previously set to 10ms, but some board (OrangePI0)
> +	 * need more if no cable plugged. 100ms seems OK
> +	 */
> +	return readl_poll_timeout(ioaddr + EMAC_BASIC_CTL1, v,
> +				  !(v & 0x01), 100, 100000);
> +}
> +
>  /* sun8i_dwmac_dma_reset() - reset the EMAC
>   * Called from stmmac via stmmac_dma_ops->reset
>   */
>  static int sun8i_dwmac_dma_reset(void __iomem *ioaddr)
>  {
> +	int ret;
> +
> +	/* The PHY receive clock must be running for the reset to complete. */
> +	ret = sun8i_dwmac_reset(ioaddr);
> +	if (ret)
> +		return ret;
> +
>  	writel(0, ioaddr + EMAC_RX_CTL1);
>  	writel(0, ioaddr + EMAC_TX_CTL1);
>  	writel(0, ioaddr + EMAC_RX_FRM_FLT);
> @@ -738,27 +759,6 @@ static void sun8i_dwmac_flow_ctrl(struct mac_device_info *hw,
>  	writel(v, ioaddr + EMAC_TX_FLOW_CTL);
>  }
>  
> -static int sun8i_dwmac_reset(struct stmmac_priv *priv)
> -{
> -	u32 v;
> -	int err;
> -
> -	v = readl(priv->ioaddr + EMAC_BASIC_CTL1);
> -	writel(v | 0x01, priv->ioaddr + EMAC_BASIC_CTL1);
> -
> -	/* The timeout was previously set to 10ms, but some board (OrangePI0)
> -	 * need more if no cable plugged. 100ms seems OK
> -	 */
> -	err = readl_poll_timeout(priv->ioaddr + EMAC_BASIC_CTL1, v,
> -				 !(v & 0x01), 100, 100000);
> -
> -	if (err) {
> -		dev_err(priv->device, "EMAC reset timeout\n");
> -		return err;
> -	}
> -	return 0;
> -}
> -
>  /* Search in mdio-mux node for internal PHY node and get its clk/reset */
>  static int get_ephy_nodes(struct stmmac_priv *priv)
>  {
> @@ -895,7 +895,9 @@ static int mdio_mux_syscon_switch_fn(int current_child, int desired_child,
>  		/* After changing syscon value, the MAC need reset or it will
>  		 * use the last value (and so the last PHY set).
>  		 */
> -		ret = sun8i_dwmac_reset(priv);
> +		ret = sun8i_dwmac_reset(priv->ioaddr);
> +		if (ret)
> +			dev_err(priv->device, "EMAC reset timeout\n");
>  	}
>  	return ret;
>  }
> @@ -1217,10 +1219,6 @@ static int sun8i_dwmac_probe(struct platform_device *pdev)
>  			dev_err(&pdev->dev, "Failed to register mux\n");
>  			goto dwmac_mux;
>  		}
> -	} else {
> -		ret = sun8i_dwmac_reset(priv);
> -		if (ret)
> -			goto dwmac_remove;
>  	}
>  
>  	pm_runtime_put(&pdev->dev);
>