[PATCH v5 20/25] drm/tilcdc: Use devm_drm_of_get_bridge() helper

[Luca Ceresoli]

Hi Kory,

On Fri Jan 23, 2026 at 5:12 PM CET, Kory Maincent (TI.com) wrote:
> Replace drm_of_find_panel_or_bridge() with the newer
> devm_drm_of_get_bridge() helper which simplifies the code by:
> - Automatically handling both panel and bridge cases internally
> - Managing the panel-to-bridge conversion when needed
> - Using devres for resource management, eliminating manual cleanup
>
> This removes the need for explicit panel-to-bridge conversion via
> devm_drm_panel_bridge_add_typed() and the associated error handling path.
>
> Signed-off-by: Kory Maincent (TI.com) <kory.maincent at bootlin.com>

I'm OK with this patch, based on the v4 discussion. I have a question
however, see below.

> --- a/drivers/gpu/drm/tilcdc/tilcdc_encoder.c
> +++ b/drivers/gpu/drm/tilcdc/tilcdc_encoder.c
> @@ -55,15 +55,12 @@ int tilcdc_encoder_create(struct drm_device *ddev)
>  	struct tilcdc_drm_private *priv = ddev_to_tilcdc_priv(ddev);
>  	struct tilcdc_encoder *encoder;
>  	struct drm_bridge *bridge;
> -	struct drm_panel *panel;
> -	int ret;
>
> -	ret = drm_of_find_panel_or_bridge(ddev->dev->of_node, 0, 0,
> -					  &panel, &bridge);
> -	if (ret == -ENODEV)
> +	bridge = devm_drm_of_get_bridge(ddev->dev, ddev->dev->of_node, 0, 0);
> +	if (PTR_ERR(bridge) == -ENODEV)
>  		return 0;
> -	else if (ret)
> -		return ret;
> +	else if (IS_ERR(bridge))
> +		return PTR_ERR(bridge);
>
>  	encoder = drmm_simple_encoder_alloc(ddev, struct tilcdc_encoder,
>  					    base, DRM_MODE_ENCODER_NONE);
> @@ -73,12 +70,5 @@ int tilcdc_encoder_create(struct drm_device *ddev)
>  	}
>  	priv->encoder = encoder;
>
> -	if (panel) {
> -		bridge = devm_drm_panel_bridge_add_typed(ddev->dev, panel,
> -							 DRM_MODE_CONNECTOR_DPI);

You are introducing a subtle difference here: while you pass the connector
type to devm_drm_panel_bridge_add_typed(), devm_drm_of_get_bridge() does
not take it and expects it to ahve been set previously and errors out if it
hasn't.

Can you ensure the connector type is alway set before this
devm_drm_of_get_bridge() call?

All the changes to the driver in the previous patches of this series make
it hard to find that out from here.

Luca

--
Luca Ceresoli, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com