[PATCH 2/3] arm64: dts: imx93-11x11-evk: change usdhc tuning step for eMMC and SD

[ziniu.wang_1 at nxp.com]

From: Luke Wang <ziniu.wang_1 at nxp.com>

For eMMC and SD, there are two tuning pass windows and the gap between
those two windows may only have one cell. If tuning step > 1, the gap may
just be skipped and host assumes those two windows as a continuous
windows. This will cause a bad delay cell near the gap to be selected.

For SDIO, the gap is big enough, default tuning step is fine.

Signed-off-by: Luke Wang <ziniu.wang_1 at nxp.com>
---
 arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts b/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts
index b94a24193e19..6da2d25acbd0 100644
--- a/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx93-11x11-evk.dts
@@ -632,6 +632,7 @@ &usdhc1 {
 	pinctrl-2 = <&pinctrl_usdhc1_200mhz>;
 	bus-width = <8>;
 	non-removable;
+	fsl,tuning-step = <1>;
 	status = "okay";
 };
 
@@ -644,6 +645,7 @@ &usdhc2 {
 	cd-gpios = <&gpio3 00 GPIO_ACTIVE_LOW>;
 	vmmc-supply = <&reg_usdhc2_vmmc>;
 	bus-width = <4>;
+	fsl,tuning-step = <1>;
 	status = "okay";
 	no-mmc;
 };
-- 
2.34.1