[PATCH] arm64: dts: ti: k3-am62l: support cpufreq

[Kendall Willis]

On 1/22/26 10:14, Kendall Willis wrote:
> On 1/22/26 04:49, Dhruva Gole wrote:
>> Enable CPUFreq support for AM62L SoC by adding the relevant OPP efuse 
>> table
>> syscon to k3-am62l-wakeup.dtsi for speed grade detection.
>>
>> Add the operating-points-v2 table with CPU frequency steps from 200MHz to
>> 1.25GHz to k3-am62l3.dtsi
>>
>> Configure CPU clocks to reference the SCMI clock controller for frequency
>> scaling
>>
>> This enables proper CPU frequency scaling capabilities for the AM62L SoC
>> using the ARM SCMI protocol to interact with the power management 
>> firmware.
>>
>> Signed-off-by: Dhruva Gole <d-gole at ti.com>
> 
> Reviewed-by: Kendall Willis <k-willis at ti.com>
> 
> Best,
> Kendall Willis <k-willis at ti.com>

Oops sent my reviewed by on the wrong revision.

Best,
Kendall Willis