[PATCH net-next 0/9] net: stmmac: qcom-ethqos: further serdes reorganisation

[Vladimir Oltean]

Hi Vinod,

On Fri, Feb 27, 2026 at 07:17:05PM +0530, Vinod Koul wrote:
> On 25-02-26, 09:02, Russell King (Oracle) wrote:
> > Note: only 8 patches in this series, not 9 as the subject line says,
> > as the set_clk_tx_rate() patch became part of the first series.
> > 
> > On Wed, Feb 25, 2026 at 09:00:41AM +0000, Russell King (Oracle) wrote:
> > > This is part 2 of the qcom-ethqos series, part 1 has now been merged.
> > > 
> > > This part of the series focuses on the generic PHY driver, but these
> > > changes have dependencies on the ethernet driver, hence why
> > > it will need to go via net-next. Furthermore, subsequent changes
> > > depend on these patches.
> 
> This lgtm, can we get signed tag so that we can pull this into phy tree
> as well

I think this series is obsolete. It has been superseded in the netdev
patchwork by:

[PATCH RESEND2 net-next 0/8] net: stmmac: qcom-ethqos: further serdes reorganisation
├─>[PATCH RESEND2 net-next 1/8] net: stmmac: qcom-ethqos: move ethqos_set_serdes_speed()
├─>[PATCH RESEND2 net-next 2/8] phy: qcom-sgmii-eth: add .set_mode() and .validate() methods
├─>[PATCH RESEND2 net-next 3/8] net: stmmac: qcom-ethqos: convert to use phy_set_mode_ext()
├─>[PATCH RESEND2 net-next 4/8] phy: qcom-sgmii-eth: remove .set_speed() implementation
├─>[PATCH RESEND2 net-next 5/8] phy: qcom-sgmii-eth: use PHY interface mode for SerDes settings
├─>[PATCH RESEND2 net-next 6/8] phy: qcom-sgmii-eth: remove qcom_dwmac_sgmii_phy_interface()
├─>[PATCH RESEND2 net-next 7/8] phy: qcom-sgmii-eth: relax order of .power_on() vs .set_mode*()
└─>[PATCH RESEND2 net-next 8/8] net: stmmac: qcom-ethqos: remove phy_set_mode_ext() after phy_power_on()

(with which it is only partially overlapping)

I guess you should give your Acks there as well.