[PATCH v4 1/3] media: dt-bindings: rockchip,vdec: Add alternative reg-names order for RK35{76,88}

[Cristian Ciocaltea]

Hi Krzysztof, Conor,

On 2/27/26 9:46 AM, Krzysztof Kozlowski wrote:
> On Thu, Feb 26, 2026 at 12:46:53PM +0200, Cristian Ciocaltea wrote:
>> With the introduction of the RK3588 SoC, and RK3576 afterwards, two more
>> register blocks have been provided for the video decoder unit.
>>
>> However, the binding does not properly describe the new hardware layout,
> 
> As you shown me last time with excerpt of address spaces from
> datasheet/manual, the binding correctly describes the hardware and above
> sentence is not true.
> 
>> as it breaks the convention expecting the unit address to indicate the
>> start of the first register range, i.e. 'function' block is listed
> 
> Imprecise wording. "start of the main or primary register range"
> 
> (if you have 0x1000 with one reg and 0x20000000 with everything, the
> unit address will be 0x20000000).
> 
>> before 'link' instead of the opposite.
>>
>> Since the binding changes have been already released and a fix would
>> bring up an ABI break, mark the current 'reg-names' ordering as
>> deprecated and introduce an alternative 'link,function,cache' listing
>> which follows the address-based ordering according to the TRM.
>>
>> Additionally, drop the 'reg' description items as the order is not fixed
>> anymore, while the information they offer is not very relevant anyway.
> 
> This is fine for me.

Thanks for the additional feedback!

If I'm not mistaken (please correct me), the only remaining (hard)
blocker for the series would be to improve this commit message.

How about the following:

    With the introduction of the RK3588 SoC, and RK3576 afterwards, three
    register blocks have been provided for the video decoder unit instead of
    just one, which are further referenced in the datasheet by 'link table',
    'function' and 'cache'.  The former is present at the top of the
    listing, starting at video decoder unit base address.

    However, while documenting RK3588, the binding broke the convention
    expecting the unit address to indicate the start of the primary register
    range, i.e. the 'function' block got listed before the 'link' one.

    Since the binding changes have been already released and a fix would
    bring up an ABI break, mark the current 'reg-names' ordering as
    deprecated and introduce an alternative 'link,function,cache' listing
    which follows the address-based ordering according to the TRM.

    Additionally, drop the 'reg' description items as the order is not fixed
    anymore, while the information they offer is not very relevant anyway.

Regards,
Cristian