[PATCH v3 1/3] media: dt-bindings: rockchip,vdec: Add alternative reg-names order for RK35{76,88}

[Krzysztof Kozlowski]

On 25/02/2026 15:11, Krzysztof Kozlowski wrote:
> On 25/02/2026 14:36, Cristian Ciocaltea wrote:
>> On 2/25/26 2:26 PM, Krzysztof Kozlowski wrote:
>>> On 25/02/2026 13:19, Cristian Ciocaltea wrote:
>>>> With the introduction of the RK3588 SoC, and RK3576 afterwards, the
>>>> 'link' and 'cache' register blocks have been provided for the video
>>>> decoder unit in addition to the existing 'function' one, which now shows
>>>> up in between them (from address-based ordering point of view).
>>>>
>>>> However, the binding does not properly describe this hardware layout, as
>>>> the new blocks are listed after the old one.  Therefore it breaks the
>>>> convention expecting the unit address to indicate the first register
>>>> range.
>>>>
>>>> Since the binding changes have been already released and a fix would
>>>> bring up an ABI break, mark the current 'reg-names' listing as
>>>> deprecated and introduce an alternative 'link,function,cache' one.
>>>>
>>>> Additionally, drop the 'reg' description items as the order is not fixed
>>>> anymore, while the information they offer is not very relevant anyway.
>>>>
>>>> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea at collabora.com>
>>>> ---
>>>>  .../devicetree/bindings/media/rockchip,vdec.yaml      | 19 ++++++++++++-------
>>>>  1 file changed, 12 insertions(+), 7 deletions(-)
>>>>
>>>> diff --git a/Documentation/devicetree/bindings/media/rockchip,vdec.yaml b/Documentation/devicetree/bindings/media/rockchip,vdec.yaml
>>>> index 809fda45b3bd..3f6072e8baa5 100644
>>>> --- a/Documentation/devicetree/bindings/media/rockchip,vdec.yaml
>>>> +++ b/Documentation/devicetree/bindings/media/rockchip,vdec.yaml
>>>> @@ -28,16 +28,21 @@ properties:
>>>>  
>>>>    reg:
>>>>      minItems: 1
>>>> -    items:
>>>> -      - description: The function configuration registers base
>>>> -      - description: The link table configuration registers base
>>>> -      - description: The cache configuration registers base
>>>> +    maxItems: 3
>>>>  
>>>>    reg-names:
>>>> -    items:
>>>> +    oneOf:
>>>>        - const: function
>>>
>>> This is confusing, I think I missed that in previous patch because it
>>> did not leave that part or I misread the diff hunk - why do you allow
>>> one entry?
>>
>> That's for the older SoCs, e.g. RK3288, RK3399, as the 'link' and 'cache' blocks
>> are only available for RK3576 & RK3588.
> 
> Yeah, I see in the bottom of the binding
> 
>>
>>>
>>> If the first entry is function, then all others MUST built on top, thus
>>> this:
>>>
>>>> +          - const: link
>>>> +          - const: function
>>>> +          - const: cache
>>>
>>> is not correct.
>>>
>>> No, you don't change the orders. So again, if you have such binding,
>>> then you just fix the unit address leaving the binding as is.
>>
>> Changing the unit address would mean it will point inside the register range,
>> rather than at the beginning of it.
> 
> First, not true. If this was one register range, you would have one
> entry. You cannot split entries. Split entries means you have two
> SEPARATE register ranges.
> Second, it does not matter because main rule stays - the unit address
> describes the main address space. The main address space in other device
> was called "function", so I assume the main address space is also here
> the "function". Which makes sense, because link feels secondary to
> functioning of the device.
> 
>>
>> Sorry, but I don't quite get why would this be a better approach than just
>> properly list the items according to the HW layout, i.e. following the
>> address-based ordering?

One more comment here, actually repeating Rob, because this awfully
reminds me discussions with Linaro folks around media/iris/camss where
they came with terrible idea of sorting everything by value
(reg+clocks+interrupts) - because binding does not know anything about
addresses, thus you cannot sort/order this list in the binding by
address. There is simple no "key" to sort with.

Best regards,
Krzysztof