[PATCH RFC net-next 3/7] net: stmmac: use integrated PCS for BASE-X modes
Russell King (Oracle)
rmk+kernel at armlinux.org.uk
Wed Feb 25 03:44:39 PST 2026
dwmac-qcom-ethqos supports SGMII and 2500BASE-X using the integrated
PCS, so we need to expand the PCS support to include support for
BASE-X modes.
Add support to the prereset configuration to detect 2500BASE-X, and
arrange for stmmac_mac_select_pcs() to return the integrated PCS if
its supported_interfaces bitmap reports support for the interface mode.
This results in priv->hw->pcs now being write-only, so remove it.
Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
drivers/net/ethernet/stmicro/stmmac/common.h | 4 ----
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++------
2 files changed, 2 insertions(+), 10 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/common.h b/drivers/net/ethernet/stmicro/stmmac/common.h
index d26e8a063022..6492af5f8a06 100644
--- a/drivers/net/ethernet/stmicro/stmmac/common.h
+++ b/drivers/net/ethernet/stmicro/stmmac/common.h
@@ -277,9 +277,6 @@ struct stmmac_safety_stats {
#define FLOW_TX 2
#define FLOW_AUTO (FLOW_TX | FLOW_RX)
-/* PCS defines */
-#define STMMAC_PCS_SGMII (1 << 1)
-
#define SF_DMA_MODE 1 /* DMA STORE-AND-FORWARD Operation Mode */
/* DMA HW feature register fields */
@@ -634,7 +631,6 @@ struct mac_device_info {
unsigned int unicast_filter_entries;
unsigned int mcast_bits_log2;
unsigned int rx_csum;
- unsigned int pcs;
unsigned int xlgmac;
unsigned int num_vlan;
u32 vlan_filter[32];
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index d7c730179a7f..1eeae680d777 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -953,11 +953,8 @@ static struct phylink_pcs *stmmac_mac_select_pcs(struct phylink_config *config,
return pcs;
}
- /* The PCS control register is only relevant for SGMII, TBI and RTBI
- * modes. We no longer support TBI or RTBI, so only configure this
- * register when operating in SGMII mode with the integrated PCS.
- */
- if (priv->hw->pcs & STMMAC_PCS_SGMII && priv->integrated_pcs)
+ if (priv->integrated_pcs &&
+ test_bit(interface, priv->integrated_pcs->pcs.supported_interfaces))
return &priv->integrated_pcs->pcs;
return NULL;
@@ -1215,7 +1212,6 @@ static void stmmac_check_pcs_mode(struct stmmac_priv *priv)
if (priv->dma_cap.pcs && interface == PHY_INTERFACE_MODE_SGMII) {
netdev_dbg(priv->dev, "PCS SGMII support enabled\n");
- priv->hw->pcs = STMMAC_PCS_SGMII;
switch (speed) {
case SPEED_10:
--
2.47.3
More information about the linux-arm-kernel
mailing list