[PATCH 4/6] mtd: rawnand: sunxi: replace hard coded value by a define - take2

[Richard Genoud]

The user data length (4) has been replaced almost all over the file, but
2 places were forgotten.

The user data is placed before the ECC, for each step.
So, in sunxi_nfc_hw_ecc_read_extra_oob(), the offset of the user data in
OOB is indeed ((ecc->bytes + USER_DATA_SZ) * ecc->steps);

And in sunxi_nand_ooblayout_ecc(), the offset of the ECC chunk in OOB is
the same offset plus the current user data size:
section * (ecc->bytes + USER_DATA_SZ) + USER_DATA_SZ;

Fixes: 1be7ac78b72f ("mtd: rawnand: sunxi: Replace hard coded value by a define")
Signed-off-by: Richard Genoud <richard.genoud at bootlin.com>
---
 drivers/mtd/nand/raw/sunxi_nand.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/raw/sunxi_nand.c b/drivers/mtd/nand/raw/sunxi_nand.c
index 99d305bbda53..5d925b59b618 100644
--- a/drivers/mtd/nand/raw/sunxi_nand.c
+++ b/drivers/mtd/nand/raw/sunxi_nand.c
@@ -1051,7 +1051,7 @@ static void sunxi_nfc_hw_ecc_read_extra_oob(struct nand_chip *nand,
 {
 	struct mtd_info *mtd = nand_to_mtd(nand);
 	struct nand_ecc_ctrl *ecc = &nand->ecc;
-	int offset = ((ecc->bytes + 4) * ecc->steps);
+	int offset = ((ecc->bytes + USER_DATA_SZ) * ecc->steps);
 	int len = mtd->oobsize - offset;
 
 	if (len <= 0)
@@ -1747,7 +1747,7 @@ static int sunxi_nand_ooblayout_ecc(struct mtd_info *mtd, int section,
 	if (section >= ecc->steps)
 		return -ERANGE;
 
-	oobregion->offset = section * (ecc->bytes + USER_DATA_SZ) + 4;
+	oobregion->offset = section * (ecc->bytes + USER_DATA_SZ) + USER_DATA_SZ;
 	oobregion->length = ecc->bytes;
 
 	return 0;