[PATCH v1 09/11] arm64: dts: imx8mm-var-som-symphony: Add TPM2 support

[Stefano Radaelli]

From: Stefano Radaelli <stefano.r at variscite.com>

Add support for the TPM2 device on the VAR-SOM Symphony carrier board.

The ST33K TPM2 is connected over I2C, and A PCA6408 GPIO expander is
used to control the reset signal required to release the TPM from reset.

This patch adds:
- The PCA6408 GPIO expander.
- The ST33K TPM2 device node.

Signed-off-by: Stefano Radaelli <stefano.r at variscite.com>
---
 .../boot/dts/freescale/imx8mm-var-som-symphony.dts | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-var-som-symphony.dts b/arch/arm64/boot/dts/freescale/imx8mm-var-som-symphony.dts
index 40ffa1f36b2f..b4dba1961eee 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-var-som-symphony.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-var-som-symphony.dts
@@ -137,6 +137,20 @@ typec1_dr_sw: endpoint {
 };
 
 &i2c3 {
+	pca6408: gpio at 21 {
+		compatible = "nxp,pcal6408";
+		reg = <0x21>;
+		gpio-controller;
+		#gpio-cells = <2>;
+	};
+
+	st33ktpm2xi2c: tpm at 2e {
+		compatible = "st,st33ktpm2xi2c", "tcg,tpm-tis-i2c";
+		reg = <0x2e>;
+		label = "tpm";
+		reset-gpios = <&pca6408 4 GPIO_ACTIVE_LOW>;
+	};
+
 	/* Capacitive touch controller */
 	ft5x06_ts: touchscreen at 38 {
 		compatible = "edt,edt-ft5406";
-- 
2.47.3