[PATCH] ARM: tegra: paz00: use software nodes to describe GPIOs for WiFi rfkill

[Marc Dietrich]

Hallo Chen-Yu,

On Sat, 14 Feb 2026, Chen-Yu Tsai wrote:

> On Sat, Feb 14, 2026 at 10:27 PM Marc Dietrich <marvin24 at gmx.de> wrote:
>>
>> Hi Dimitry,
>>
>> On Wed, 11 Feb 2026, Dmitry Torokhov wrote:
>>
>>> Hi Thierry,
>>>
>>> On Fri, Jun 28, 2024 at 05:35:08PM +0200, Thierry Reding wrote:
>>>> From: Thierry Reding <treding at nvidia.com>
>>>>
>>>>
>>>> On Wed, 26 Jun 2024 21:46:13 -0700, Dmitry Torokhov wrote:
>>>>> Complete conversion of the WiFi rfkill device to use device
>>>>> properties/software nodes by utilizing PROPERTY_ENTRY_GPIO() instead of
>>>>> a lookup table.
>>>>>
>>>>>
>>>>
>>>> Applied, thanks!
>>>>
>>>> [1/1] ARM: tegra: paz00: use software nodes to describe GPIOs for WiFi rfkill
>>>>       commit: 47ac458bb229f8c4864081d173adbcfc55c34880
>>>
>>> Do you know by any chance why paz00 does not simply configure rfkill
>>> switch via device tree? The driver (rfkill-gpio) seem to support device
>>> tree...
>>
>> last time I tried this was rejected because the wifi chip is on the usb
>> bus and "rfkill" should be a sub-function of this chip [1], but that was
>> some time ago...
>>
>> Looking hard the schematics, the wifi chip does not have a gpio input as
>> first thought. Rather it seems that the first gpio toggles a regulator
>> which supplies the wifi module (m2 card) with power and the second gpio is
>> just connected to the wifi LED.
>>
>> Not sure how to transfer this into dt, but I guess this would be the
>> better solution.
>
> Then the first GPIO should probably just be described as a fixed regulator
> feeding the USB controller that the M.2 module is connected to.

I think that is what rfkill-gpio is for, so the proposal of 
Dimitry looks fine, execpt for the reset-gpio, aka LED which is 
already included in the dt (but maybe with the wrong gpio).

I will give it a try on real HW and report back.

Thanks!

Marc