[PATCH] arm64: dts: ti: k3-am62d2-evm: Set wakeup-source system-states

[Dhruva Gole]

On Feb 12, 2026 at 14:07:16 -0600, Kendall Willis wrote:
> The CANUART pins of mcu_mcan0, mcu_mcan1, mcu_uart0 and wkup_uart0 are
> powered during Partial-IO and I/O Only + DDR and are capable of waking
> up the system in these states. Specify the states in which these units
> can do a wakeup on this board.
> 
> Note that the UARTs are not capable of wakeup in Partial-IO because of
> of a UART mux on the board not being powered during Partial-IO.
> 
> Add pincontrol definitions for mcu_mcan0 and mcu_mcan1 for wakeup from
> Partial-IO. Add these as wakeup pinctrl entries for both devices.
> 
> Signed-off-by: Kendall Willis <k-willis at ti.com>
> ---
> This patch is based on a similar commit afb919a6b36b ("arm64: dts: ti:
> k3-am62a7-sk: Set wakeup-source system-states") Markus made for the AM62A
> SoC.

Reviewed-by: Dhruva Gole <d-gole at ti.com>



-- 
Best regards,
Dhruva Gole
Texas Instruments Incorporated