[PATCH RFC net-next 5/9] net: stmmac: qcom-ethqos: move loopback disable to .mac_finish()

[Russell King (Oracle)]

Loopback is enabled to allow the dwmac soft reset to succeed. This
is enabled when clocks are enabled in ethqos_clks_config(), which
happens at driver probe and runtime PM resume - e.g. when the
network device is administratively brought up.

Currently, the loopback is disabled when the link comes up (via
.mac_link_up() calling this driver's .fix_mac_speed().)

Move the qcom_ethqos_set_sgmii_loopback() call which disables
loopback from ethqos_fix_mac_speed() into ethqos' SerDes specific
.mac_finish() method so that loopback is disabled a little earlier
after reset has completed, and dwmac setup has completed.

Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 .../net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c | 13 ++++++++++++-
 1 file changed, 12 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
index 964eca46a653..bd5d3bf90400 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
@@ -647,7 +647,6 @@ static void ethqos_fix_mac_speed(void *priv, int speed, unsigned int mode)
 {
 	struct qcom_ethqos *ethqos = priv;
 
-	qcom_ethqos_set_sgmii_loopback(ethqos, false);
 	ethqos_update_link_clk(ethqos, speed);
 	ethqos_configure(ethqos, speed);
 }
@@ -684,6 +683,17 @@ static void qcom_ethqos_serdes_powerdown(struct net_device *ndev, void *priv)
 	phy_exit(ethqos->serdes_phy);
 }
 
+static int ethqos_mac_finish_serdes(struct net_device *ndev, void *priv,
+				    unsigned int mode,
+				    phy_interface_t interface)
+{
+	struct qcom_ethqos *ethqos = priv;
+
+	qcom_ethqos_set_sgmii_loopback(ethqos, false);
+
+	return 0;
+}
+
 static int ethqos_clks_config(void *priv, bool enabled)
 {
 	struct qcom_ethqos *ethqos = priv;
@@ -770,6 +780,7 @@ static int qcom_ethqos_probe(struct platform_device *pdev)
 	case PHY_INTERFACE_MODE_2500BASEX:
 	case PHY_INTERFACE_MODE_SGMII:
 		ethqos->configure_func = ethqos_configure_sgmii;
+		plat_dat->mac_finish = ethqos_mac_finish_serdes;
 		break;
 	default:
 		dev_err(dev, "Unsupported phy mode %s\n",
-- 
2.47.3