[PATCH v2 1/2] dt-bindings: ethernet: eswin: add clock sampling control

[Andrew Lunn]

> The rx-internal-delay-ps and tx-internal-delay-ps properties now use
> minimum and maximum constraints to reflect the actual hardware delay
> range (0-2400 ps) applied in 20 ps steps.


>    rx-internal-delay-ps:
> -    enum: [0, 200, 600, 1200, 1600, 1800, 2000, 2200, 2400]
> +    minimum: 0
> +    maximum: 2400

       multipleOf: 20

Also, 2400 / 20 = 120. Is the real maximum 127 * 20 = 2540?

> @@ -111,17 +129,44 @@ examples:
>          interrupts = <61>;
>          interrupt-names = "macirq";
>          phy-mode = "rgmii-id";
> -        phy-handle = <&phy0>;
> +        phy-handle = <&gmac0_phy0>;
>          resets = <&reset 95>;
>          reset-names = "stmmaceth";
> +        rx-internal-delay-ps = <20>;
> +        tx-internal-delay-ps = <100>;

I would not include them in the example. You are going to get
developers blindly copying this into real DT. A well designed board
should not need delays.

	Andrew