[PATCH v2 2/3] arm64: dts: nuvoton: ma35d1: add display controller support

[Krzysztof Kozlowski]

On 06/02/2026 08:12, Joey Lu wrote:
> 
> On 2/5/2026 9:23 PM, Krzysztof Kozlowski wrote:
>> On Thu, Jan 29, 2026 at 12:05:31PM +0800, Joey Lu wrote:
>>>   &uart0 {
>>> @@ -129,3 +165,23 @@ &uart16 {
>>>   	pinctrl-0 = <&pinctrl_uart16>;
>>>   	status = "okay";
>>>   };
>>> +
>>> +&panel {
>>> +	port {
>>> +		panel_in: endpoint at 0 {
>>> +			remote-endpoint = <&dpi_out>;
>>> +		};
>>> +	};
>>> +};
>>> +
>>> +&display {
>> What sort of ordering rule is followed in Nuvoton? Why is it different
>> than DTS coding style? Why do you choose other style?
>>
>>> +	pinctrl-names = "default";
>>> +	pinctrl-0 = <&pinctrl_display>;
>>> +	status = "okay";
>>> +
>>> +	port {
>>> +		dpi_out: endpoint at 0 {
>>> +			remote-endpoint = <&panel_in>;
>>> +		};
>>> +	};
>>> +};
>>> diff --git a/arch/arm64/boot/dts/nuvoton/ma35d1.dtsi b/arch/arm64/boot/dts/nuvoton/ma35d1.dtsi
>>> index e51b98f5bdce..7d9d077f12b2 100644
>>> --- a/arch/arm64/boot/dts/nuvoton/ma35d1.dtsi
>>> +++ b/arch/arm64/boot/dts/nuvoton/ma35d1.dtsi
>>> @@ -379,5 +379,19 @@ uart16: serial at 40880000 {
>>>   			clocks = <&clk UART16_GATE>;
>>>   			status = "disabled";
>>>   		};
>>> +
>>> +		panel: panel {
>> No, there is no way your SoC has a panel.
>>
>> Don't add fake stuff to your DTS.
>>
>> Best regards,
>> Krzysztof
> 
> I'll move panel nodes out of dtsi into board dts.

You did not respond to several comments in total, it's fine, but if you
just ignored them, then it would not be fine.


Best regards,
Krzysztof