[PATCH 2/3] clk: keystone: don't cache clock rate

[Randolph Sapp]

On Mon Sep 15, 2025 at 9:34 AM CDT, Michael Walle wrote:
> The TISCI firmware will return 0 if the clock or consumer is not
> enabled although there is a stored value in the firmware. IOW a call to
> set rate will work but at get rate will always return 0 if the clock is
> disabled.
> The clk framework will try to cache the clock rate when it's requested
> by a consumer. If the clock or consumer is not enabled at that point,
> the cached value is 0, which is wrong. Thus, disable the cache
> altogether.
>
> Signed-off-by: Michael Walle <mwalle at kernel.org>
> ---
> I guess to make it work correctly with the caching of the linux
> subsystem a new flag to query the real clock rate is needed. That
> way, one could also query the default value without having to turn
> the clock and consumer on first. That can be retrofitted later and
> the driver could query the firmware capabilities.
>
> Regarding a Fixes: tag. I didn't include one because it might have a
> slight performance impact because the firmware has to be queried
> every time now and it doesn't have been a problem for now. OTOH I've
> enabled tracing during boot and there were just a handful
> clock_{get/set}_rate() calls.
> ---
>  drivers/clk/keystone/sci-clk.c | 8 ++++++++
>  1 file changed, 8 insertions(+)
>
> diff --git a/drivers/clk/keystone/sci-clk.c b/drivers/clk/keystone/sci-clk.c
> index c5894fc9395e..d73858b5ca7a 100644
> --- a/drivers/clk/keystone/sci-clk.c
> +++ b/drivers/clk/keystone/sci-clk.c
> @@ -333,6 +333,14 @@ static int _sci_clk_build(struct sci_clk_provider *provider,
>  
>  	init.ops = &sci_clk_ops;
>  	init.num_parents = sci_clk->num_parents;
> +
> +	/*
> +	 * A clock rate query to the SCI firmware will return 0 if either the
> +	 * clock itself is disabled or the attached device/consumer is disabled.
> +	 * This makes it inherently unsuitable for the caching of the clk
> +	 * framework.
> +	 */
> +	init.flags = CLK_GET_RATE_NOCACHE;
>  	sci_clk->hw.init = &init;
>  
>  	ret = devm_clk_hw_register(provider->dev, &sci_clk->hw);


Thanks for looking into this Michael. I'm still convinced that it's unusual to
report 0 for a clock rate when the device is powered down. In most cases it's
not actually 0 and is actually just in bypass mode.

I was told it's a way to indicate clock status and probably won't be changing
any time soon though. Ignore the fact that we also already have a separate way
to query clock status. :)

This series looks good, but won't quite result in a functional GPU without the
following patch: https://lore.kernel.org/all/20250808232522.1296240-1-rs@ti.com/

I suppose I'll submit that again on it's own.

Reviewed-by: Randolph Sapp <rs at ti.com>