[PATCH v2 3/3] arm64: dts: add Protonic PRT8ML board

[Andrew Lunn]

> +			port at 4 {
> +				reg = <4>;
> +				ethernet = <&fec>;
> +				label = "cpu";
> +				phy-mode = "rgmii-id";
> +				rx-internal-delay-ps = <2000>;
> +				tx-internal-delay-ps = <2000>;
> +
> +				fixed-link {
> +					full-duplex;
> +					speed = <100>;
> +				};
> +			};
> +		};
> +	};
> +};
> +
> +&fec {
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pinctrl_fec>;
> +	phy-mode = "rgmii"; /* switch inserts delay */
> +	rx-internal-delay-ps = <0>;
> +	tx-internal-delay-ps = <0>;
> +	status = "okay";
> +
> +	fixed-link {
> +		full-duplex;
> +		speed = <100>;
> +	};

You have an RGMII interface, but you run it at 100Mbps? That might be
worth a comment somewhere to explain why.

	Andrew