[PATCH v2 3/5] net: cadence: macb: Add support for Raspberry Pi RP1 ethernet controller

[Stanimir Varbanov]

Hi Andrew,

Thank you the answer!

On 9/15/25 4:34 PM, Andrew Lunn wrote:
> On Mon, Sep 15, 2025 at 02:27:34PM +0300, Stanimir Varbanov wrote:
>>
>>
>> On 9/10/25 2:32 PM, Stanimir Varbanov wrote:
>>> Hi Jakub,
>>>
>>> On 8/22/25 12:34 PM, Stanimir Varbanov wrote:
>>>> From: Dave Stevenson <dave.stevenson at raspberrypi.com>
>>>>
>>>> The RP1 chip has the Cadence GEM block, but wants the tx_clock
>>>> to always run at 125MHz, in the same way as sama7g5.
>>>> Add the relevant configuration.
>>>>
>>>> Signed-off-by: Dave Stevenson <dave.stevenson at raspberrypi.com>
>>>> Signed-off-by: Stanimir Varbanov <svarbanov at suse.de>
>>>> Reviewed-by: Andrew Lunn <andrew at lunn.ch>
>>>> ---
>>>>  drivers/net/ethernet/cadence/macb_main.c | 12 ++++++++++++
>>>>  1 file changed, 12 insertions(+)
>>>>
>>>
>>> This patch is missing in net-next but ("dt-bindings: net: cdns,macb: Add
>>> compatible for Raspberry Pi RP1") from this series has been applied.
>>>
>>> Could you take this patch as well, please.
>>
>> Gentle ping.
> 
> Such pings are ignored. Please rebase the patch to net-next and submit
> it again.

Sorry about that.

I did not realized that if it applies cleanly on net-next I need to
re-send it.

I will send it as a separate one with version v3.

~Stan