[PATCH 0/6] remoteproc: imx_proc: Simplify driver by removing the switch-case

[Peng Fan]

This patchset serves as a preparing patchset for i.MX95 support.

The current code logic is complicated, with mix the usage of switch-case
and if-else.

To simplify the code logic:
 Introduce struct imx_rproc_plat_ops to wrap platform start,stop,detect_mode.
 Each imx_rproc_dcfg data structure is assigned a ops pointer.
 The common imx_rproc_{start,stop}() directly invokes the plat ops, no
 need the switch-case.
 mmio/smc/scu_api ops are included.
 No functional changes.

Thanks to Daniel and Frank for the help.

Test on i.MX8MM for MMIO ops, i.MX8MP for SMC ops. For SCU-API ops,
I currently not have a setup at hand, I will give a setup and test
later, but everything should be fine, no functional changes.

Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
Peng Fan (6):
      remoteproc: imx_rproc: Introduce start/stop/detect_mode ops for imx_rproc_dcfg
      remoteproc: imx_rproc: Move imx_rproc_dcfg closer to imx_rproc_of_match
      remoteproc: imx_rproc: Simplify IMX_RPROC_MMIO switch case
      remoteproc: imx_rproc: Simplify IMX_RPROC_SCU_API switch case
      remoteproc: imx_rproc: Simplify IMX_RPROC_SMC switch case
      remoteproc: imx_rproc: Clean up after ops introduction

 drivers/remoteproc/imx_rproc.c | 448 +++++++++++++++++++++++------------------
 drivers/remoteproc/imx_rproc.h |   7 +
 2 files changed, 264 insertions(+), 191 deletions(-)
---
base-commit: 3e8e5822146bc396d2a7e5fbb7be13271665522a
change-id: 20250908-imx-rproc-cleanup-6f3b546b9fdf

Best regards,
-- 
Peng Fan <peng.fan at nxp.com>