[PATCH 0/1] Enable HDMI Receiver on NanoPC-T6

[Marcin Juszkiewicz]

For quite a while I had this patch in my local tree but never made it
work. Kernel generates the following messages all the time:

fdee0000.hdmi_receiver: hdmirx_wait_signal_lock: signal not lock, tmds_clk_ratio:0
fdee0000.hdmi_receiver: hdmirx_wait_signal_lock: mu_st:0x2, scdc_st:0x0, dma_st10:0x10

"v4l2-ctrl --all" reports that HDMI In is detected, /dev/video[0-4]
exist.

I tried two signal sources:
- AMD Radeon WX2100 (via passive DisplayPort -> HDMI adapter)
- AMD Radeon RX6700XT (HDMI port)

Same situation with both - kernel messages as above on RK3588 system, no
connected monitor on host side.

Usually I used MPlayer or MPV to check v4l2 devices but here it fails
too:

$ mpv av://v4l2:/dev/video3
[ffmpeg/demuxer] video4linux2,v4l2: Not a video capture device.
[lavf] avformat_open_input() failed
Failed to recognize file format.
Exiting... (Errors when loading file)


Checked SBC schematics again and HDMIIRX_DET_L line is GPIO1_D5 like it
my patch.

What I go wrong?

Marcin Juszkiewicz (1):
  arm64: dts: rockchip: enable HDMI Receiver on NanoPC T6

 .../boot/dts/rockchip/rk3588-nanopc-t6.dtsi     | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)

-- 
2.51.0