[PATCH 1/2] arm64: dts: broadcom: rp1: Add USB nodes

[Stanimir Varbanov]

Hi Andrea,

Thank you for the patch!

On 8/28/25 4:50 PM, Andrea della Porta wrote:
> The RaspberryPi 5 has RP1 chipset containing two USB host controller,
> while presenting two USB 2.0 and two USB 3.0 ports to the outside.
> 
> Add the relevant USB nodes to the devicetree.
> 
> Signed-off-by: Andrea della Porta <andrea.porta at suse.com>
> ---
>  arch/arm64/boot/dts/broadcom/rp1-common.dtsi | 28 ++++++++++++++++++++
>  1 file changed, 28 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/broadcom/rp1-common.dtsi b/arch/arm64/boot/dts/broadcom/rp1-common.dtsi
> index 5002a375eb0b..116617fcb1eb 100644
> --- a/arch/arm64/boot/dts/broadcom/rp1-common.dtsi
> +++ b/arch/arm64/boot/dts/broadcom/rp1-common.dtsi
> @@ -39,4 +39,32 @@ rp1_gpio: pinctrl at 400d0000 {
>  			     <1 IRQ_TYPE_LEVEL_HIGH>,
>  			     <2 IRQ_TYPE_LEVEL_HIGH>;
>  	};
> +
> +	rp1_usb0: usb at 40200000 {
> +		reg = <0x00 0x40200000  0x0 0x100000>;
> +		compatible = "snps,dwc3";
> +		dr_mode = "host";
> +		interrupts = <31 IRQ_TYPE_EDGE_RISING>;
> +		usb3-lpm-capable;
> +		snps,dis_rxdet_inp3_quirk;
> +		snps,parkmode-disable-ss-quirk;
> +		snps,parkmode-disable-hs-quirk;
> +		snps,tx-max-burst = /bits/ 8 <8>;
> +		snps,tx-thr-num-pkt = /bits/ 8 <2>;
> +		status = "disabled";
> +	};
> +

I'd order the generic properties first and then vendor specific.
Something like this:

rp1_usb0: usb at 40200000 {
	compatible = "snps,dwc3";
	reg = <0x00 0x40200000 0x0 0x100000>;
	interrupts = <31 IRQ_TYPE_EDGE_RISING>;
	dr_mode = "host";
        ....
}

> +	rp1_usb1: usb at 40300000 {
> +		reg = <0x00 0x40300000  0x0 0x100000>;
> +		compatible = "snps,dwc3";
> +		dr_mode = "host";
> +		interrupts = <36 IRQ_TYPE_EDGE_RISING>;
> +		usb3-lpm-capable;
> +		snps,dis_rxdet_inp3_quirk;
> +		snps,parkmode-disable-ss-quirk;
> +		snps,parkmode-disable-hs-quirk;
> +		snps,tx-max-burst = /bits/ 8 <8>;
> +		snps,tx-thr-num-pkt = /bits/ 8 <2>;
> +		status = "disabled";
> +	};
>  };