[PATCH 05/16] ARM: dts: imx6qdl-aristainetos2: rename ethernet-phy to ethernet-phy at 0

[Heiko Schocher]

Hello Fabio, Frank,

On 04.09.25 01:37, Fabio Estevam wrote:
> Hi Frank,
> 
> Thanks for working on this series.

+1

> On Wed, Sep 3, 2025 at 5:20 PM Frank Li <Frank.Li at nxp.com> wrote:
>>
>> Rename ethernet-phy to ethernet-phy at 0 to fix below CHECK_DTB warnings:
>>    arch/arm/boot/dts/nxp/imx/imx6dl-aristainetos2_4.dtb: ethernet at 2188000 (fsl,imx6q-fec): mdio: Unevaluated properties are not allowed ('ethernet-phy' was unexpected)
> ....
> 
>> -               ethphy: ethernet-phy {
>> +               ethphy: ethernet-phy at 0 {
>>                          compatible = "ethernet-phy-ieee802.3-c22";
>> +                       reg = <0>;
> 
> Are you sure the Ethernet PHY is actually at address 0?
> 
> The board schematics are often needed to get this information.
> 
> I'm adding Heiko on CC in case he can confirm.

Yep, Frank was lucky, phy is @0

So, I am fine with that change.

bye,
Heiko
-- 
Nabla Software Engineering
HRB 40522 Augsburg
Phone: +49 821 45592596
E-Mail: office at nabladev.com
Geschäftsführer : Stefano Babic