[PATCH] PCI: mvebu: Fix the use of the for_each_of_range() iterator

[Klaus Kudielka]

The blamed commit simplifies code, by using the for_each_of_range()
iterator. But it results in no pci devices being detected anymore on
Turris Omnia (and probably other mvebu targets).

Analysis:

To determine range.flags, of_pci_range_parser_one() uses bus->get_flags(),
which resolves to of_bus_pci_get_flags(). That function already returns an
IORESOURCE bit field, and NOT the original flags from the "ranges"
resource.

Then mvebu_get_tgt_attr() attempts the very same conversion again.
But this is a misinterpretation of range.flags.

Remove the misinterpretation of range.flags in mvebu_get_tgt_addr(),
to restore the intended behavior.

Signed-off-by: Klaus Kudielka <klaus.kudielka at gmail.com>
Fixes: 5da3d94a23c6 ("PCI: mvebu: Use for_each_of_range() iterator for parsing "ranges"")
Reported-by: Bjorn Helgaas <helgaas at kernel.org>
Closes: https://lore.kernel.org/r/20250820184603.GA633069@bhelgaas/
Reported-by: Jan Palus <jpalus at fastmail.com>
Closes: https://bugzilla.kernel.org/show_bug.cgi?id=220479
---
 drivers/pci/controller/pci-mvebu.c | 14 ++------------
 1 file changed, 2 insertions(+), 12 deletions(-)

diff --git a/drivers/pci/controller/pci-mvebu.c b/drivers/pci/controller/pci-mvebu.c
index 755651f338..4e2e1fa197 100644
--- a/drivers/pci/controller/pci-mvebu.c
+++ b/drivers/pci/controller/pci-mvebu.c
@@ -1168,9 +1168,6 @@ static void __iomem *mvebu_pcie_map_registers(struct platform_device *pdev,
 	return devm_ioremap_resource(&pdev->dev, &port->regs);
 }
 
-#define DT_FLAGS_TO_TYPE(flags)       (((flags) >> 24) & 0x03)
-#define    DT_TYPE_IO                 0x1
-#define    DT_TYPE_MEM32              0x2
 #define DT_CPUADDR_TO_TARGET(cpuaddr) (((cpuaddr) >> 56) & 0xFF)
 #define DT_CPUADDR_TO_ATTR(cpuaddr)   (((cpuaddr) >> 48) & 0xFF)
 
@@ -1189,17 +1186,10 @@ static int mvebu_get_tgt_attr(struct device_node *np, int devfn,
 		return -EINVAL;
 
 	for_each_of_range(&parser, &range) {
-		unsigned long rtype;
 		u32 slot = upper_32_bits(range.bus_addr);
 
-		if (DT_FLAGS_TO_TYPE(range.flags) == DT_TYPE_IO)
-			rtype = IORESOURCE_IO;
-		else if (DT_FLAGS_TO_TYPE(range.flags) == DT_TYPE_MEM32)
-			rtype = IORESOURCE_MEM;
-		else
-			continue;
-
-		if (slot == PCI_SLOT(devfn) && type == rtype) {
+		if (slot == PCI_SLOT(devfn) &&
+		    type == (range.flags & IORESOURCE_TYPE_BITS)) {
 			*tgt = DT_CPUADDR_TO_TARGET(range.cpu_addr);
 			*attr = DT_CPUADDR_TO_ATTR(range.cpu_addr);
 			return 0;
-- 
2.50.1