[PATCH v7 00/10] Add support for RK3588 DisplayPort Controller

[Maud Spierings]

Hello Andy,

> There are two DW DPTX based DisplayPort Controller on rk3588 which
> are compliant with the DisplayPort Specification Version 1.4 with
> the following features:
> 
> * DisplayPort 1.4a
> * Main Link: 1/2/4 lanes
> * Main Link Support 1.62Gbps, 2.7Gbps, 5.4Gbps and 8.1Gbps
> * AUX channel 1Mbps
> * Single Stream Transport(SST)
> * Multistream Transport (MST)
> * Type-C support (alternate mode)
> * HDCP 2.2, HDCP 1.3
> * Supports up to 8/10 bits per color component
> * Supports RBG, YCbCr4:4:4, YCbCr4:2:2, YCbCr4:2:0
> * Pixel clock up to 594MHz
> * I2S, SPDIF audio interface
> 
> The current version of this patch series only supports basic display outputs.
> I conducted tests with DP0 in 1080p and 4K at 60 YCbCr4:2:0 modes; the ALT/Type-C
> mode was tested on Rock 5B

Is there an example of this? I want to implement it for the usb-c port 
on the orangepi 5 plus, but I can't quite figure out where I would have 
to link the DP output endpoint to?

The usb-c endpoints are all done. Is it to another endpoint in the 
usbdp_phy? The only endpoints there seem to be outputs. Or is it 
supposed to be left unconnected for the ALT/type-C mode?

I've tried reading through all the relevant dt-bindings but can't find it.

Kind regards,
Maud