[PATCH v2] clk: scmi: migrate round_rate() to determine_rate()

[Peng Fan]

On Fri, Aug 29, 2025 at 10:59:15AM +0100, Sudeep Holla wrote:
>On Fri, Aug 29, 2025 at 06:09:03PM +0800, Peng Fan wrote:
>> On Wed, Aug 27, 2025 at 01:12:07PM -0400, Brian Masney wrote:
>> >This driver implements both the determine_rate() and round_rate() clk
>> >ops, and the round_rate() clk ops is deprecated. When both are defined,
>> >clk_core_determine_round_nolock() from the clk core will only use the
>> >determine_rate() clk ops.
>> >
>> >The existing scmi_clk_determine_rate() is a noop implementation that
>> >lets the firmware round the rate as appropriate. Drop the existing
>> >determine_rate implementation and convert the existing round_rate()
>> >implementation over to determine_rate().
>> >
>> >scmi_clk_determine_rate() was added recently when the clock parent
>> >support was added, so it's not expected that this change will regress
>> >anything.
>> >
>> >Signed-off-by: Brian Masney <bmasney at redhat.com>
>> 
>> Reviewed-by: Peng Fan <peng.fan at nxp.com>
>
>Peng,
>
>It would be great if you can test it with parent clock support on i.MX
>platforms just to be sure this doesn't regress anything.

Just gave a test on i.MX95-EVK, it boots well and eth0 works, 
the results in /sys/kernel/debug/clk/clk_summary also looks correct.

Tested-by: Peng Fan <peng.fan at nxp.com> #i.MX95-19x19-EVK

Regards
Peng

>
>-- 
>Regards,
>Sudeep