[PATCH v13 06/11] PCI: stm32: Add PCIe Endpoint support for STM32MP25

[Bjorn Helgaas]

On Wed, Aug 20, 2025 at 09:54:06AM +0200, Christian Bruel wrote:
> Add driver to configure the STM32MP25 SoC PCIe Gen1 2.5GT/s or Gen2 5GT/s
> controller based on the DesignWare PCIe core in endpoint mode.

> +static void stm32_pcie_perst_deassert(struct dw_pcie *pci)
> +{
> +	struct stm32_pcie *stm32_pcie = to_stm32_pcie(pci);
> +	struct device *dev = pci->dev;
> +	struct dw_pcie_ep *ep = &pci->ep;
> +	int ret;
> +
> +	dev_dbg(dev, "PERST de-asserted by host\n");
> +
> +	ret = pm_runtime_resume_and_get(dev);
> +	if (ret < 0) {
> +		dev_err(dev, "Failed to resume runtime PM: %d\n", ret);
> +		return;
> +	}
> +
> +	ret = stm32_pcie_enable_resources(stm32_pcie);
> +	if (ret) {
> +		dev_err(dev, "Failed to enable resources: %d\n", ret);
> +		goto err_pm_put_sync;
> +	}
> +
> +	/*
> +	 * Need to reprogram the configuration space registers here because the
> +	 * DBI registers were incorrectly reset by the PHY RCC during phy_init().

Is this incorrect reset of DBI registers a software issue or some kind
of hardware erratum that might be fixed someday?  Or maybe it's just a
characteristic of the hardware and thus not really "incorrect"?

I do see that qcom_pcie_perst_deassert() in pcie-qcom-ep.c also calls
dw_pcie_ep_init_registers() in the qcom_pcie_ep_perst_irq_thread()
path.

So does pex_ep_event_pex_rst_deassert() (pcie-tegra194.c) in the
tegra_pcie_ep_pex_rst_irq() path.

But as far as I can tell, none of the other dwc drivers need this, so
maybe it's something to do with the glue around the DWC core?

> +	 */
> +	ret = dw_pcie_ep_init_registers(ep);
> +	if (ret) {
> +		dev_err(dev, "Failed to complete initialization: %d\n", ret);
> +		goto err_disable_resources;
> +	}