[PATCH v4 2/6] net: stmmac: Inverse the phy-mode definition

[Yijie Yang]

On 2025-08-20 00:20, Andrew Lunn wrote:
>>   static int ethqos_rgmii_macro_init(struct qcom_ethqos *ethqos, int speed)
>>   {
>>   	struct device *dev = &ethqos->pdev->dev;
>> -	int phase_shift;
>> +	int phase_shift = 0;
>>   	int loopback;
>>   
>>   	/* Determine if the PHY adds a 2 ns TX delay or the MAC handles it */
>> -	if (ethqos->phy_mode == PHY_INTERFACE_MODE_RGMII_ID ||
>> -	    ethqos->phy_mode == PHY_INTERFACE_MODE_RGMII_TXID)
>> -		phase_shift = 0;
>> -	else
>> +	if (ethqos->phy_mode == PHY_INTERFACE_MODE_RGMII_ID)
>>   		phase_shift = RGMII_CONFIG2_TX_CLK_PHASE_SHIFT_EN;
> 
> Does this one setting control both RX and TX delays? The hardware
> cannot support 2ns delay on TX, but 0ns on RX? Or 2ns on RX but 0ns on
> TX?
> 

This setting is only for Tx delay. Rx delays are taken care separately 
with DLL delays.

> 	Andrew

-- 
Best Regards,
Yijie