[PATCH v4 3/6] arm64: dts: qcom: qcs615: add ethernet node

[Yijie Yang]

On 2025-08-19 15:15, Krzysztof Kozlowski wrote:
> On 19/08/2025 08:51, Yijie Yang wrote:
>>
>>
>> On 2025-08-19 14:44, Krzysztof Kozlowski wrote:
>>> On 19/08/2025 08:35, YijieYang wrote:
>>>> From: Yijie Yang <quic_yijiyang at quicinc.com>
>>>>
>>>> Add an ethernet controller node for QCS615 SoC to enable ethernet
>>>> functionality.
>>>>
>>>> Reviewed-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>
>>>> Signed-off-by: Yijie Yang <quic_yijiyang at quicinc.com>
>>>> ---
>>>
>>>
>>> Why do you mix up DTS and net-next patches? This only makes difficult to
>>> apply it, for no benefits.
>>
>> The DTS changes and driver code modifications work together to achieve a
>> single purpose, so I included them in one patch series. Should I
>> consider splitting them into two separate series?
> Of course yes. You are just making difficult to apply this. Patches are
> completely independent and even your internal guideline asks to NOT
> combine independent patches.

The challenge with splitting this series lies in the fact that it 
attempts to reverse the incorrect semantics of phy-mode in both the 
driver code and the device tree. Selecting only part of the series would 
break Ethernet functionality on both boards.

As you can see, I’ve CC’d noautosel to prevent this issue. Given the 
circumstances, I’m wondering if it would be acceptable to leave the 
series as-is?

> 
> Best regards,
> Krzysztof

-- 
Best Regards,
Yijie