[PATCH v7 3/6] thermal: renesas: rzg3e: Add thermal driver for the Renesas RZ/G3E SoC

[Geert Uytterhoeven]

Hi John,

On Mon, 18 Aug 2025 at 18:29, John Madieu <john.madieu.xa at bp.renesas.com> wrote:
> The RZ/G3E SoC integrates a Temperature Sensor Unit (TSU) block designed
> to monitor the chip's junction temperature. This sensor is connected to
> channel 1 of the APB port clock/reset and provides temperature measurements.
>
> It also requires calibration values stored in the system controller registers
> for accurate temperature measurement. Add a driver for the Renesas RZ/G3E TSU.
>
> Signed-off-by: John Madieu <john.madieu.xa at bp.renesas.com>

> v7: Refactored driver structure:
>   - removes splinlock usage
>   - updates polling timeout as per the datasheet
>   - uses average mode to be more accurate
>   - uses polling (faster than irq mode) for get_temp() while keeping IRQ for hw
>   trip-point cross detection.
>   - adds both runtime and sleep PM support

Thanks for the update!

I only looked at the code to obtain the trim register offsets.

> --- /dev/null
> +++ b/drivers/thermal/renesas/rzg3e_thermal.c

> +static int rzg3e_thermal_parse_dt(struct rzg3e_thermal_priv *priv)
> +{
> +       struct device_node *np = priv->dev->of_node;
> +       struct of_phandle_args args;
> +       int ret;
> +
> +       ret = of_parse_phandle_with_args(np, "renesas,tsu-trim",
> +                                        "#address-cells", 0, &args);

of_parse_phandle_with_fixed_args(np, "renesas,tsu-trim", 1, 0, &args)

> +       if (ret)
> +               return dev_err_probe(priv->dev, ret,
> +                                    "Failed to parse renesas,tsu-trim\n");
> +
> +       if (args.args_count < 1) {

"!= 1", however, I think this test is no longer needed after moving
to of_parse_phandle_with_fixed_args().

> +               dev_err(priv->dev, "Invalid renesas,tsu-trim property\n");
> +               of_node_put(args.np);
> +               return -EINVAL;
> +       }
> +
> +       priv->trim_offset = args.args[0];
> +
> +       priv->syscon = syscon_node_to_regmap(args.np);
> +       of_node_put(args.np);
> +
> +       if (IS_ERR(priv->syscon))
> +               return dev_err_probe(priv->dev, PTR_ERR(priv->syscon),
> +                                    "Failed to get syscon regmap\n");
> +
> +       return 0;
> +}
Gr{oetje,eeting}s,

                        Geert

--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert at linux-m68k.org

In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
                                -- Linus Torvalds