[PATCH net-next v10 05/15] net: phy: dp83822: Add support for phy_port representation

[Maxime Chevallier]

On Sat, 26 Jul 2025 22:50:08 +0200
Andrew Lunn <andrew at lunn.ch> wrote:

> > +#if IS_ENABLED(CONFIG_OF_MDIO)
> > +		if (dp83822->fx_enabled && dp83822->fx_sd_enable)
> > +			dp83822->fx_signal_det_low =
> > +				device_property_present(&phydev->mdio.dev,
> > +							"ti,link-loss-low");
> > +
> > +		/* ti,fiber-mode is still used for backwards compatibility, but
> > +		 * has been replaced with the mdi node definition, see
> > +		 * ethernet-port.yaml
> > +		 */
> > +		if (!dp83822->fx_enabled)
> > +			dp83822->fx_enabled =
> > +				device_property_present(&phydev->mdio.dev,
> > +							"ti,fiber-mode");  
> 
> Could be my grep fu is broken but:
> 
> ~/linux$ grep -r fiber-mode arch/*
> ~/linux$ 
> 
> So it does not even appear to be used. If it is not used, do we have
> to consider backwards compatibility?
> 
> Maybe consider marking the property deprecated and point to the new
> binding?

I'd love that :)

Let's mark it as deprecated then, I'll do that for the next iteration.

Maxime

> 
> 	Andrew