[PATCH] clk: bcm: rpi: Add disp clock

[Stefan Wahren]

Am 31.05.24 um 13:18 schrieb Ivan T. Ivanov:
> On 05-31 13:06, Stefan Wahren wrote:
>> Hi Ivan,
>>
>> Am 31.05.24 um 12:20 schrieb Ivan T. Ivanov:
>>> Hi,
>>>
>>> On 05-31 11:55, Stefan Wahren wrote:
>>>> Hi Ivan,
>>>>
>>>> Am 31.05.24 um 11:27 schrieb Ivan T. Ivanov:
>>>>> From: Maxime Ripard <maxime at cerno.tech>
>>>>>
>>>>> BCM2712 has an extra clock exposed by the firmware called DISP, and used
>>>>> by (at least) the HVS. Let's add it to the list of clocks to register in
>>>>> Linux.
>>>>>
>>>>> Without this new definition driver fails at probe on BCM2712.
>>>> could you please explain the relation to Andrea's series [1]?
>>>>
>>>> How can this occur, because there is no Raspberry Pi 5 support in Mainline?
>>> I am using few out-of-tree drivers on top of the Andrea's patch-set
>>> and noticed the failure, so decided to prepare the road for RPi5.
>> okay and did you use the vendor DTB or Andreas' version?
> Patches from Andrea don't have "raspberrypi,firmware-clocks" node.
That's the reason i'm asking :-)
>
>>> I am not entirely sure what are you asking.
>> Because Andreas DTS shouldn't require this patch and we usually don't
>> include changes which are not testable with Mainline Kernel.
>>
> So I should wait Andreas' patch set to be merged in before I can post
> anything about RPi5?
No, but it would be extremely helpful for the maintainers to know, which
patches (directly or indirectly) depend on which pending series. So a
comment below the commit message (at the same place as the patch
changelog) about this would be nice in this case.
>
> Regards,
> Ivan
>