[PATCH RFC net-next v2 8/8] net: stmmac: Activate Inband/PCS flag based on the selected iface

Russell King (Oracle) rmk+kernel at armlinux.org.uk
Fri May 31 04:26:51 PDT 2024


From: Serge Semin <fancer.lancer at gmail.com>

The HWFEATURE.PCSSEL flag is set if the PCS block has been synthesized
into the DW GMAC controller. It's always done if the controller supports
at least one of the SGMII, TBI, RTBI PHY interfaces. If none of these
interfaces support was activated during the IP-core synthesize the PCS
block won't be activated either and the HWFEATURE.PCSSEL flag won't be
set. Based on that the RGMII in-band status detection procedure
implemented in the driver hasn't been working for the devices with the
RGMII interface support and with none of the SGMII, TBI, RTBI PHY
interfaces available in the device.

Fix that just by dropping the dma_cap.pcs flag check from the conditional
statement responsible for the In-band/PCS functionality activation. If the
RGMII interface is supported by the device then the in-band link status
detection will be also supported automatically (it's always embedded into
the RGMII RTL code). If the SGMII interface is supported by the device
then the PCS block will be supported too (it's unconditionally synthesized
into the controller). The later is also correct for the TBI/RTBI PHY
interfaces.

Note while at it drop the netdev_dbg() calls since at the moment of the
stmmac_check_pcs_mode() invocation the network device isn't registered. So
the debug prints will be for the unknown/NULL device.

Signed-off-by: Serge Semin <fancer.lancer at gmail.com>
[rmk: fix build errors, only use PCS for SGMII if priv->dma_cap.pcs is set]
Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 .../net/ethernet/stmicro/stmmac/stmmac_main.c    | 16 ++++------------
 1 file changed, 4 insertions(+), 12 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index ad19ba42c412..4384d61a3bcd 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1132,18 +1132,10 @@ static void stmmac_check_pcs_mode(struct stmmac_priv *priv)
 {
 	int interface = priv->plat->mac_interface;
 
-	if (priv->dma_cap.pcs) {
-		if ((interface == PHY_INTERFACE_MODE_RGMII) ||
-		    (interface == PHY_INTERFACE_MODE_RGMII_ID) ||
-		    (interface == PHY_INTERFACE_MODE_RGMII_RXID) ||
-		    (interface == PHY_INTERFACE_MODE_RGMII_TXID)) {
-			netdev_dbg(priv->dev, "PCS RGMII support enabled\n");
-			priv->hw->pcs = STMMAC_PCS_RGMII;
-		} else if (interface == PHY_INTERFACE_MODE_SGMII) {
-			netdev_dbg(priv->dev, "PCS SGMII support enabled\n");
-			priv->hw->pcs = STMMAC_PCS_SGMII;
-		}
-	}
+	if (phy_interface_mode_is_rgmii(interface))
+		priv->hw->pcs = STMMAC_PCS_RGMII;
+	else if (priv->dma_cap.pcs && interface == PHY_INTERFACE_MODE_SGMII)
+		priv->hw->pcs = STMMAC_PCS_SGMII;
 }
 
 /**
-- 
2.30.2




More information about the linux-arm-kernel mailing list