[PATCH] arm64: dts: rockchip: add rfkill node for M.2 Key E Bluetooth on Rock 5B

Alexey Charkov alchark at gmail.com
Fri May 17 05:25:08 PDT 2024


By default the BT WAKE signal inside the M.2 key E connector on Radxa
Rock 5B is driven low, which results in the Bluetooth function being
disabled even if the inserted M.2 card supports it. Expose this signal
as an RFKILL device so that it can be enabled by the userspace.

Tested with an Intel AX210 card, which connects a Bluetooth device over
the USB 2.0 bus.

Signed-off-by: Alexey Charkov <alchark at gmail.com>
---
 arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
index b70313643af8..27dd95f92f33 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
@@ -65,6 +65,13 @@ rfkill {
 		shutdown-gpios = <&gpio4 RK_PA2 GPIO_ACTIVE_HIGH>;
 	};
 
+	rfkill-bt {
+		compatible = "rfkill-gpio";
+		label = "rfkill-m2-bt";
+		radio-type = "bluetooth";
+		shutdown-gpios = <&gpio3 RK_PD5 GPIO_ACTIVE_HIGH>;
+	};
+
 	vcc3v3_pcie2x1l0: vcc3v3-pcie2x1l0-regulator {
 		compatible = "regulator-fixed";
 		enable-active-high;
-- 
2.45.0




More information about the linux-arm-kernel mailing list