[PATCH] arm64: dts: imx8mp: Enable HDMI on i.MX8MP DHCOM PDK2 and PDK3

[Ahmad Fatoum]

On 16.05.24 13:44, Marek Vasut wrote:
> On 5/16/24 1:36 PM, Ahmad Fatoum wrote:
>> Hello Marek,
> 
> Hi,
> 
>> On 16.05.24 13:14, Marek Vasut wrote:
>>> On 5/16/24 10:00 AM, Francesco Dolcini wrote:
>>>> Hello Marek,
>>>
>>> Hi,
>>>
>>>> On Tue, May 14, 2024 at 03:06:42AM +0200, Marek Vasut wrote:
>>>>> Enable HDMI output on i.MX8MP DHCOM PDK2 and PDK3. The I2C5 on PDK2 and
>>>>> I2C mux port 1 on PDK3 respectively are used in regular I2C mode instead
>>>>> of HDMI DDC mode to permit connection of other I2C devices on those buses.
>>>>
>>>> Are you able to read the HDMI EDID with such configuration? I have the
>>>> patch ready for verdin imx8mp, I just did not have time to figure out
>>>> this last details.
>>>
>>> Yes with ddc-i2c-bus in hdmi_tx{} node, no with ddc-i2c-bus in connector node. Maybe that's what you're running into ? The DW HDMI core needs the ddc-i2c-bus property in hdmi_tx{} node if you use non-native I2C bus for the DDC channel.
>>
>> What benefit does the hdmi-connector provide over just omitting it?
>> Just for documentation purposes?
> 
> I was under the impression describing the hardware in DT in full was the best practice (TM), hence it is in full here.

Sure, I am just wondering what effect, if any, it has in how Linux interprets
the device tree. I have an i.MX8MP board with HDMI as well, but without
connector (yet).

Cheers,
Ahmad

> 

-- 
Pengutronix e.K.                           |                             |
Steuerwalder Str. 21                       | http://www.pengutronix.de/  |
31137 Hildesheim, Germany                  | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |