[PATCH v4 2/3] dt-bindings: arm: mediatek: mmsys: Add OF graph support for board path

CK Hu (胡俊光) ck.hu at mediatek.com
Thu May 16 02:23:09 PDT 2024


Hi, Angelo:

On Thu, 2024-05-16 at 10:11 +0200, AngeloGioacchino Del Regno wrote:
> Document OF graph on MMSYS/VDOSYS: this supports up to three DDP paths
> per HW instance (so potentially up to six displays for multi-vdo SoCs).
> 
> The MMSYS or VDOSYS is always the first component in the DDP pipeline,
> so it only supports an output port with multiple endpoints - where each
> endpoint defines the starting point for one of the (currently three)
> possible hardware paths.
> 
> Reviewed-by: Rob Herring (Arm) <robh at kernel.org>
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno at collabora.com>
> ---
>  .../bindings/arm/mediatek/mediatek,mmsys.yaml | 28 +++++++++++++++++++
>  1 file changed, 28 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/arm/mediatek/mediatek,mmsys.yaml b/Documentation/devicetree/bindings/arm/mediatek/mediatek,mmsys.yaml
> index b3c6888c1457..0ef67ca4122b 100644
> --- a/Documentation/devicetree/bindings/arm/mediatek/mediatek,mmsys.yaml
> +++ b/Documentation/devicetree/bindings/arm/mediatek/mediatek,mmsys.yaml
> @@ -93,6 +93,34 @@ properties:
>    '#reset-cells':
>      const: 1
>  
> +  port:
> +    $ref: /schemas/graph.yaml#/properties/port
> +    description:
> +      Output port node. This port connects the MMSYS/VDOSYS output to
> +      the first component of one display pipeline, for example one of
> +      the available OVL or RDMA blocks.
> +      Some MediaTek SoCs support multiple display outputs per MMSYS.

The display pipeline number usually depend on how many display interface. Display interface is in the end of pipeline.

In below case, two RDMA is merged into one pipeline and output to one display interface DP_INTF. This is usually ONE display.

RDMA -+
      Merge -> ... -> DP_INTF
RDMA -+

In below case, one RDMA data output to two display interface DSI and DPI. This is usually TWO display with the same content.

               +-> DSI
RDMA -> ... -> +
               +-> DPI

So the display pipeline number does not depend on the number of first component. It usually depend on the number of display interface.

Regards,
CK


> +    properties:
> +      endpoint at 0:
> +        $ref: /schemas/graph.yaml#/properties/endpoint
> +        description: Output to the primary display pipeline
> +
> +      endpoint at 1:
> +        $ref: /schemas/graph.yaml#/properties/endpoint
> +        description: Output to the secondary display pipeline
> +
> +      endpoint at 2:
> +        $ref: /schemas/graph.yaml#/properties/endpoint
> +        description: Output to the tertiary display pipeline
> +
> +    oneOf:
> +      - required:
> +          - endpoint at 0
> +      - required:
> +          - endpoint at 1
> +      - required:
> +          - endpoint at 2
> +
>  required:
>    - compatible
>    - reg


More information about the linux-arm-kernel mailing list