[PATCH 0/2] firmware: arm_scmi: add notification completion channel

[Peng Fan (OSS)]

Per spec:
Completion interrupts This transport supports polling or interrupt driven
modes of communication. In interrupt mode, when the callee completes
processing a message, it raises an interrupt to the caller. Hardware
support for completion interrupts is optional.

i.MX95 SCMI firmware is fully interrupt driven, so Platform expects
completion interrupt for Platform to Agent(P2A) notifictions.

Add another optional mailbox channel for Agent to notify Platform that
notification message has been accepted

After notification channel status become freed, Agent will use the
new mailbox channel to send completion interrupt to Platform.

Add shmem_channel_intr_enabled to check channel flags.

Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
Peng Fan (2):
      dt-bindings: firmware: arm,scmi: Support notification completion channel
      firmware: arm_scmi: mailbox: support P2A channel completion

 .../devicetree/bindings/firmware/arm,scmi.yaml     | 12 +++--
 drivers/firmware/arm_scmi/common.h                 |  1 +
 drivers/firmware/arm_scmi/mailbox.c                | 51 +++++++++++++++++++---
 drivers/firmware/arm_scmi/shmem.c                  |  5 +++
 4 files changed, 59 insertions(+), 10 deletions(-)
---
base-commit: 9221b2819b8a4196eecf5476d66201be60fbcf29
change-id: 20240507-scmi-notify-07e87a8b9a23

Best regards,
-- 
Peng Fan <peng.fan at nxp.com>