[PATCH v4 4/4] arm64: dts: add description for solidrun cn9131 solidwan board

[Josua Mayer]

Am 02.05.24 um 14:32 schrieb Josua Mayer:
> Add description for the SolidRun CN9131 SolidWAN, based on CN9130 SoM
> with an extra communication  processor on the carrier board.
>
> This board differentiates itself from CN9130 Clearfog by providing
> additional SoC native network interfaces and pci buses:
> 2x 10Gbps SFP+
> 4x 1Gbps RJ45
> 1x miniPCI-E
> 1x m.2 b-key with sata, usb-2.0 and usb-3.0
> 1x m.2 m-key with pcie and usb-2.0
> 1x m.2 b-key with pcie, usb-2.0, usb-3.0 and 2x sim slots
> 1x mpcie with pcie only
> 2x type-a usb-2.0/3.0
>
> Signed-off-by: Josua Mayer <josua at solid-run.com>
> ---
>  arch/arm64/boot/dts/marvell/Makefile               |   1 +
>  arch/arm64/boot/dts/marvell/cn9131-cf-solidwan.dts | 643 +++++++++++++++++++++
>  2 files changed, 644 insertions(+)
>
cut
> +	/* Type-A port on J53 */
> +	reg_usb_a_vbus0: regulator-usb-a-vbus0 {
> +		compatible = "regulator-fixed";
> +		pinctrl-0 = <&cp0_reg_usb_a_vbus0_pins>;
> +		pinctrl-names = "default";
> +		regulator-name = "vbus0";
> +		regulator-min-microvolt = <5000000>;
> +		regulator-max-microvolt = <5000000>;
> +		regulator-oc-protection-microamp = <1000000>;

Is it correct to specify over-current protection for a regulator-fixed? It causes kernel messages:

[ 7.988337] vbus0: IC does not support requested over-current limits [ 7.994756] vbus0: IC does not support requested over voltage limits [ 7.998796] vbus1: IC does not support requested over-current limits ...

The reason I put the property was that the 1A limit is a property of the regulator component (NCP380-1.0A). Maybe that is the wrong property?

It also generates an interrupt for which I found no suitable description.

> +		gpio = <&cp0_gpio1 27 GPIO_ACTIVE_HIGH>;
> +		enable-active-high;
> +		regulator-always-on;
> +	};
> +
> +	reg_usb_a_vbus1: regulator-usb-a-vbus1 {
> +		compatible = "regulator-fixed";
> +		pinctrl-0 = <&cp0_reg_usb_a_vbus1_pins>;
> +		pinctrl-names = "default";
> +		regulator-name = "vbus1";
> +		regulator-min-microvolt = <5000000>;
> +		regulator-max-microvolt = <5000000>;
> +		regulator-oc-protection-microamp = <1000000>;
same here
> +		gpio = <&cp0_gpio1 28 GPIO_ACTIVE_HIGH>;
> +		enable-active-high;
> +		regulator-always-on;
> +	};
> +