[PATCH v2 2/3] net: stmmac: Add interconnect support
Sagar Cheluvegowda
quic_scheluve at quicinc.com
Fri Jun 28 12:43:04 PDT 2024
On 6/26/2024 12:40 AM, Krzysztof Kozlowski wrote:
> On 26/06/2024 01:49, Sagar Cheluvegowda wrote:
>> Add interconnect support to vote for bus bandwidth based
>> on the current speed of the driver.This change adds support
>
> Please do not use "This commit/patch/change", but imperative mood. See
> longer explanation here:
> https://elixir.bootlin.com/linux/v5.17.1/source/Documentation/process/submitting-patches.rst#L95
>
> Also, space after full stop.
> Agreed, i will fix this in my next patch.
>> for two different paths - one from ethernet to DDR and the
>> other from Apps to ethernet.
>> Vote from each interconnect client is aggregated and the on-chip
>> interconnect hardware is configured to the most appropriate
>> bandwidth profile.
>>
>> Suggested-by: Andrew Halaney <ahalaney at redhat.com>
>> Signed-off-by: Sagar Cheluvegowda <quic_scheluve at quicinc.com>
>> ---
>> drivers/net/ethernet/stmicro/stmmac/stmmac.h | 1 +
>> drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 8 ++++++++
>> drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c | 12 ++++++++++++
>> include/linux/stmmac.h | 2 ++
>> 4 files changed, 23 insertions(+)
>>
>> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac.h b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
>> index b23b920eedb1..56a282d2b8cd 100644
>> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac.h
>> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
>> @@ -21,6 +21,7 @@
>> #include <linux/ptp_clock_kernel.h>
>> #include <linux/net_tstamp.h>
>> #include <linux/reset.h>
>> +#include <linux/interconnect.h>
>> #include <net/page_pool/types.h>
>> #include <net/xdp.h>
>> #include <uapi/linux/bpf.h>
>> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>> index b3afc7cb7d72..ec7c61ee44d4 100644
>> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
>> @@ -985,6 +985,12 @@ static void stmmac_fpe_link_state_handle(struct stmmac_priv *priv, bool is_up)
>> }
>> }
>>
>> +static void stmmac_set_icc_bw(struct stmmac_priv *priv, unsigned int speed)
>> +{
>> + icc_set_bw(priv->plat->axi_icc_path, Mbps_to_icc(speed), Mbps_to_icc(speed));
>> + icc_set_bw(priv->plat->ahb_icc_path, Mbps_to_icc(speed), Mbps_to_icc(speed));
>> +}
>> +
>> static void stmmac_mac_link_down(struct phylink_config *config,
>> unsigned int mode, phy_interface_t interface)
>> {
>> @@ -1080,6 +1086,8 @@ static void stmmac_mac_link_up(struct phylink_config *config,
>> if (priv->plat->fix_mac_speed)
>> priv->plat->fix_mac_speed(priv->plat->bsp_priv, speed, mode);
>>
>> + stmmac_set_icc_bw(priv, speed);
>> +
>> if (!duplex)
>> ctrl &= ~priv->hw->link.duplex;
>> else
>> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
>> index 54797edc9b38..e46c94b643a3 100644
>> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
>> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_platform.c
>> @@ -642,6 +642,18 @@ stmmac_probe_config_dt(struct platform_device *pdev, u8 *mac)
>> dev_dbg(&pdev->dev, "PTP rate %d\n", plat->clk_ptp_rate);
>> }
>>
>> + plat->axi_icc_path = devm_of_icc_get(&pdev->dev, "axi");
>> + if (IS_ERR(plat->axi_icc_path)) {
>> + ret = (void *)plat->axi_icc_path;
>> + goto error_hw_init;
>
> This sounds like an ABI break. Considering the interconnects are not
> required by the binding, are you sure this behaves correctly without
> interconnects in DTS?
>
> Best regards,
> Krzysztof
>
Yes, i did check without the interconnect entries in the dtsi and
things are working fine, devm_of_icc_get is properly clearing out
all the references in the case when "interconnects" are not present
in the dtsi.
In the stmmac driver we are only handling the error case and
if the entries are not present in the dtsi we are simply continuing with
the regular code flow.
Regards,
Sagar
More information about the linux-arm-kernel
mailing list