[PATCH 5/7] arm64: dts: ti: k3-j784s4: Add cpsw-mac-efuse node to mcu_conf

[Andrew Davis]

The MCU system controller address region contains an eFuse block with
MAC addresses to be used by the Ethernet controller. The property
“ti,syscon-efuse” contains a phandle to a syscon region and an offset
into this region where the MAC addresses can be found. Currently
"ti,syscon-efuse" points to the entire system controller address space
node with an offset to the eFuse IP address.

Instead add a cpsw-mac-efuse node to describe the exact eFuse area. Then
point the Ethernet controller directly to this region, no offset needed.

This makes it so the system controller memory area does not need to be one
big syscon area, describe this bus address area as the simple-bus it is.

Signed-off-by: Andrew Davis <afd at ti.com>
---
 arch/arm64/boot/dts/ti/k3-j784s4-mcu-wakeup.dtsi | 14 +++++++++-----
 1 file changed, 9 insertions(+), 5 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-j784s4-mcu-wakeup.dtsi b/arch/arm64/boot/dts/ti/k3-j784s4-mcu-wakeup.dtsi
index 2e18d91ae92f8..f3a6ed1c979d0 100644
--- a/arch/arm64/boot/dts/ti/k3-j784s4-mcu-wakeup.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j784s4-mcu-wakeup.dtsi
@@ -145,12 +145,16 @@ mcu_timerio_output: pinctrl at 40f04280 {
 		status = "reserved";
 	};
 
-	mcu_conf: syscon at 40f00000 {
-		compatible = "ti,j721e-system-controller", "syscon", "simple-mfd";
-		reg = <0x00 0x40f00000 0x00 0x20000>;
+	mcu_conf: bus at 40f00000 {
+		compatible = "simple-bus";
 		#address-cells = <1>;
 		#size-cells = <1>;
-		ranges = <0x00 0x00 0x40f00000 0x20000>;
+		ranges = <0x0 0x0 0x40f00000 0x20000>;
+
+		cpsw_mac_syscon: ethernet-mac-syscon at 200 {
+			compatible = "ti,am62p-cpsw-mac-efuse", "syscon";
+			reg = <0x200 0x8>;
+		};
 
 		phy_gmii_sel: phy at 4040 {
 			compatible = "ti,am654-phy-gmii-sel";
@@ -553,7 +557,7 @@ mcu_cpsw_port1: port at 1 {
 				reg = <1>;
 				ti,mac-only;
 				label = "port1";
-				ti,syscon-efuse = <&mcu_conf 0x200>;
+				ti,syscon-efuse = <&cpsw_mac_syscon 0x0>;
 				phys = <&phy_gmii_sel 1>;
 			};
 		};
-- 
2.39.2