[PATCH 0/7] Add PCIe support for bcm2712

[Stanimir Varbanov]

This patchset aims to add bare minimum support for bcm2712
in brcmstb PCIe driver needed to support the peripherals from
RP1 south-bridge found in RPi5. In order to support RP1
PCIe endpoint peripherals a new interrupt controller is added.
The interrupt controller supports 64 interrupt sources which
are enough to handle 61 RP1 peripherals.

Patch 1 is adding DT binding schema for the MIP interrupt
controller, patch 2 is adding relevant changes for PCIe
bcm2712 in yaml. Patch 3 adds MIP intterrupt cotroller driver.
Patches 4 and 5 are preparations for adding bcm2712 support in 6.
The last patch updates bcm2712 .dsti by adding pcie DT nodes.

Few concerns about the implementation:
 - the connection between MIP interrupt-controller and PCIe RC is 
   done through BAR1. The PCIe driver is parsing the msi_parent
   DT property in order to obtain few private DT properties like 
   "brcm,msi-pci-addr" and "reg". IMO this looks hackish but I failed
   to find something better. Ideas? 

 - in downstream RPi kernel "ranges" and "dma-ranges" DT properties 
   are under an axi {} simple-bus node even that PCIe block is on CPU
   MMIO bus. I tried to merge axi {} in soc {} and the result could be
   seen on the last patch in this series, but I'm still not sure that
   it looks good enough.

This series has been functionally tested on OpenSUSE Tumbleweed with
downstream RP1 south-bridge PCIe endpoint driver implementation as
MFD by using ethernet which is part of it. 

The series is based on Andrea's "Add minimal boot support for Raspberry Pi 5"
series.

Comments are welcome!

regards,
~Stan

Stanimir Varbanov (7):
  dt-bindings: interrupt-controller: Add bcm2712 MSI-X DT bindings
  dt-bindings: PCI: brcmstb: Update bindings for PCIe on bcm2712
  irqchip: Add Broadcom bcm2712 MSI-X interrupt controller
  PCI: brcmstb: Reuse config structure
  PCI: brcmstb: add phy_controllable flag
  PCI: brcmstb: Add bcm2712 support
  arm64: dts: broadcom: bcm2712: Add PCIe DT nodes

 .../brcm,bcm2712-msix.yaml                    |  74 +++++
 .../bindings/pci/brcm,stb-pcie.yaml           |  17 +
 arch/arm64/boot/dts/broadcom/bcm2712.dtsi     | 218 +++++++++++-
 drivers/irqchip/Kconfig                       |  12 +
 drivers/irqchip/Makefile                      |   1 +
 drivers/irqchip/irq-bcm2712-mip.c             | 287 ++++++++++++++++
 drivers/pci/controller/pcie-brcmstb.c         | 314 ++++++++++++++++--
 7 files changed, 876 insertions(+), 47 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/brcm,bcm2712-msix.yaml
 create mode 100644 drivers/irqchip/irq-bcm2712-mip.c

-- 
2.43.0