[PATCH v3 28/41] iio: light: adux1020: make use of regmap_clear_bits(), regmap_set_bits()

[Trevor Gamblin]

Instead of using regmap_update_bits() and passing the mask twice, use
regmap_set_bits().

Instead of using regmap_update_bits() and passing val = 0, use
regmap_clear_bits().

Suggested-by: Uwe Kleine-König <u.kleine-koenig at baylibre.com>
Signed-off-by: Trevor Gamblin <tgamblin at baylibre.com>
---
 drivers/iio/light/adux1020.c | 13 ++++++-------
 1 file changed, 6 insertions(+), 7 deletions(-)

diff --git a/drivers/iio/light/adux1020.c b/drivers/iio/light/adux1020.c
index aa4a6c78f0aa..34230e699d27 100644
--- a/drivers/iio/light/adux1020.c
+++ b/drivers/iio/light/adux1020.c
@@ -539,9 +539,8 @@ static int adux1020_write_event_config(struct iio_dev *indio_dev,
 		 * Trigger proximity interrupt when the intensity is above
 		 * or below threshold
 		 */
-		ret = regmap_update_bits(data->regmap, ADUX1020_REG_PROX_TYPE,
-					 ADUX1020_PROX_TYPE,
-					 ADUX1020_PROX_TYPE);
+		ret = regmap_set_bits(data->regmap, ADUX1020_REG_PROX_TYPE,
+				      ADUX1020_PROX_TYPE);
 		if (ret < 0)
 			goto fail;
 
@@ -748,8 +747,8 @@ static int adux1020_chip_init(struct adux1020_data *data)
 
 	dev_dbg(&client->dev, "Detected ADUX1020 with chip id: 0x%04x\n", val);
 
-	ret = regmap_update_bits(data->regmap, ADUX1020_REG_SW_RESET,
-				 ADUX1020_SW_RESET, ADUX1020_SW_RESET);
+	ret = regmap_set_bits(data->regmap, ADUX1020_REG_SW_RESET,
+			      ADUX1020_SW_RESET);
 	if (ret < 0)
 		return ret;
 
@@ -764,8 +763,8 @@ static int adux1020_chip_init(struct adux1020_data *data)
 		return ret;
 
 	/* Use LED_IREF for proximity mode */
-	ret = regmap_update_bits(data->regmap, ADUX1020_REG_LED_CURRENT,
-				 ADUX1020_LED_PIREF_EN, 0);
+	ret = regmap_clear_bits(data->regmap, ADUX1020_REG_LED_CURRENT,
+				ADUX1020_LED_PIREF_EN);
 	if (ret < 0)
 		return ret;
 

-- 
2.45.2