[net-next,PATCH v7 7/8] net: stmmac: dwmac-stm32: Mask support for PMCR configuration

[Christophe ROULLIER]

Hi Marek,

On 6/11/24 18:16, Marek Vasut wrote:
> On 6/11/24 3:32 PM, Christophe ROULLIER wrote:
>>
>> On 6/11/24 15:07, Marek Vasut wrote:
>>> On 6/11/24 10:36 AM, Christophe Roullier wrote:
>>>
>>> [...]
>>>
>>>>   static void stm32_dwmac_clk_disable(struct stm32_dwmac *dwmac, 
>>>> bool suspend)
>>>> @@ -348,8 +352,15 @@ static int stm32_dwmac_parse_data(struct 
>>>> stm32_dwmac *dwmac,
>>>>           return PTR_ERR(dwmac->regmap);
>>>>         err = of_property_read_u32_index(np, "st,syscon", 1, 
>>>> &dwmac->mode_reg);
>>>> -    if (err)
>>>> +    if (err) {
>>>>           dev_err(dev, "Can't get sysconfig mode offset (%d)\n", err);
>>>> +        return err;
>>>> +    }
>>>> +
>>>> +    dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
>>>> +    err = of_property_read_u32_index(np, "st,syscon", 2, 
>>>> &dwmac->mode_mask);
>>>> +    if (err)
>>>> +        dev_dbg(dev, "Warning sysconfig register mask not set\n");
>>>
>>> My comment on V6 was not addressed I think ?
>>
>> Hi Marek,
>>
>> I put the modification in patch which introduce MP13 (V7 8/8) ;-)
>>
>>       err = of_property_read_u32_index(np, "st,syscon", 2, 
>> &dwmac->mode_mask);
>> -    if (err)
>> -        dev_dbg(dev, "Warning sysconfig register mask not set\n");
>> +    if (err) {
>> +        if (dwmac->ops->is_mp13)
>> +            dev_err(dev, "Sysconfig register mask must be set 
>> (%d)\n", err);
>> +        else
>> +            dev_dbg(dev, "Warning sysconfig register mask not set\n");
>> +    }
>
> That isn't right, is it ?
>
> For MP2 , this still checks the presence of syscon , which shouldn't 
> be checked at all for MP2 as far as I understand it ?

When I will push MP2 serie, I will bypass the check of mask syscfg. I 
will push MP2 after MP13 ack.

Thanks