[PATCH v9 2/2] power: pwrseq: add a driver for the PMU module on the QCom WCN chipsets

[Krzysztof Kozlowski]

On 10/06/2024 16:55, Bartosz Golaszewski wrote:
> On Mon, Jun 10, 2024 at 4:54 PM Krzysztof Kozlowski
> <krzysztof.kozlowski at linaro.org> wrote:
>>
>> On 05/06/2024 14:38, Bartosz Golaszewski wrote:
>>> From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
>>>
>>> This adds the power sequencing driver for the PMU modules present on the
>>> Qualcomm WCN Bluetooth and Wifi chipsets. It uses the pwrseq subsystem
>>> and knows how to match the sequencer to the consumer device by verifying
>>> the relevant properties and DT layout. Using this driver will allow the
>>> BT and WLAN drivers to respect the required delays between enabling the
>>> two modules.
>>
>> ...
>>
>>> +
>>> +static const struct of_device_id pwrseq_qcom_wcn_of_match[] = {
>>> +     {
>>> +             .compatible = "qcom,qca6390-pmu",
>>> +             .data = &pwrseq_qca6390_of_data,
>>
>> Bindings *must* be part of this patchset. I missed the moment this was
>> split into such chunks.
>>
>> Best regards,
>> Krzysztof
>>
> 
> The bindings are already in next via Mark Brown's tree.

OK, I checked linux-next from a day before Mark merged it. Cover letter
should mention it, because it is a bit unusual (and would save you
reviewer's question).

Best regards,
Krzysztof