[PATCH 12/14] dt-bindings: display: rockchip,dw-hdmi: Add compatible for RK3588
Rob Herring
robh at kernel.org
Wed Jun 5 16:22:06 PDT 2024
On Sat, Jun 01, 2024 at 04:12:34PM +0300, Cristian Ciocaltea wrote:
> Document the Synopsys DesignWare HDMI 2.1 Quad-Pixel (QP) TX controller
> found on Rockchip RK3588 SoC family.
>
> Since RK3588 uses different clocks than previous Rockchip SoCs and also
> requires a couple of reset lines and some additional properties, provide
> the required changes in the binding to accommodate all variants.
>
> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea at collabora.com>
> ---
> .../display/rockchip/rockchip,dw-hdmi.yaml | 127 +++++++++++++++------
> 1 file changed, 90 insertions(+), 37 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/display/rockchip/rockchip,dw-hdmi.yaml b/Documentation/devicetree/bindings/display/rockchip/rockchip,dw-hdmi.yaml
> index 2aac62219ff6..60d6b815227f 100644
> --- a/Documentation/devicetree/bindings/display/rockchip/rockchip,dw-hdmi.yaml
> +++ b/Documentation/devicetree/bindings/display/rockchip/rockchip,dw-hdmi.yaml
> @@ -10,12 +10,10 @@ maintainers:
> - Mark Yao <markyao0591 at gmail.com>
>
> description: |
> - The HDMI transmitter is a Synopsys DesignWare HDMI 1.4 TX controller IP
> - with a companion PHY IP.
> -
> -allOf:
> - - $ref: ../bridge/synopsys,dw-hdmi.yaml#
> - - $ref: /schemas/sound/dai-common.yaml#
> + For SoCs up to RK3568, the HDMI transmitter is a Synopsys DesignWare
> + HDMI 1.4 TX controller IP with a companion PHY IP.
> + The RK3588 SoC integrates the Synopsys DesignWare HDMI 2.1 Quad-Pixel (QP)
> + TX controller IP and a HDMI/eDP TX Combo PHY based on a Samsung IP block.
>
> properties:
> compatible:
> @@ -25,6 +23,7 @@ properties:
> - rockchip,rk3328-dw-hdmi
> - rockchip,rk3399-dw-hdmi
> - rockchip,rk3568-dw-hdmi
> + - rockchip,rk3588-dw-hdmi
>
> reg-io-width:
> const: 4
> @@ -40,36 +39,6 @@ properties:
> A 1.8V supply that powers up the SoC internal circuitry. The pin name on the
> SoC usually is HDMI_TX_AVDD_1V8.
>
> - clocks:
> - minItems: 2
> - items:
> - - {}
> - - {}
> - # The next three clocks are all optional, but shall be specified in this
> - # order when present.
> - - description: The HDMI CEC controller main clock
> - - description: Power for GRF IO
> - - description: External clock for some HDMI PHY (old clock name, deprecated)
> - - description: External clock for some HDMI PHY (new name)
> -
> - clock-names:
> - minItems: 2
> - items:
> - - {}
> - - {}
> - - enum:
> - - cec
> - - grf
> - - vpll
> - - ref
> - - enum:
> - - grf
> - - vpll
> - - ref
> - - enum:
> - - vpll
> - - ref
> -
> ddc-i2c-bus:
> $ref: /schemas/types.yaml#/definitions/phandle
> description:
> @@ -131,13 +100,97 @@ properties:
> required:
> - compatible
> - reg
> - - reg-io-width
> - clocks
> - clock-names
> - interrupts
> - ports
> - rockchip,grf
>
> +allOf:
> + - $ref: /schemas/sound/dai-common.yaml#
> + - if:
> + properties:
> + compatible:
> + contains:
> + enum:
> + - rockchip,rk3588-dw-hdmi
> + then:
> + properties:
> + reg:
> + maxItems: 1
> +
> + clocks:
> + minItems: 1
> + items:
> + - description: APB system interface clock
> + # The next clocks are optional, but shall be specified in this
> + # order when present.
> + - description: TMDS/FRL link clock
> + - description: EARC RX biphase clock
> + - description: Reference clock
> + - description: Audio interface clock
> + - description: Video datapath clock
> +
> + clock-names:
> + minItems: 1
> + items:
> + - const: pclk
> + - enum: [hdp, earc, ref, aud, hclk_vo1]
> + - enum: [earc, ref, aud, hclk_vo1]
> + - enum: [ref, aud, hclk_vo1]
> + - enum: [aud, hclk_vo1]
> + - const: hclk_vo1
> +
> + resets:
> + minItems: 2
> + maxItems: 2
> +
> + reset-names:
> + items:
> + - const: ref
> + - const: hdp
> +
> + interrupts:
> + minItems: 1
> + maxItems: 5
> +
> + rockchip,vo1_grf:
> + $ref: /schemas/types.yaml#/definitions/phandle
> + description: Some QP related data is accessed through VO1 GRF regs
> +
> + required:
> + - resets
> + - reset-names
> + - rockchip,vo1_grf
> +
> + else:
> + $ref: ../bridge/synopsys,dw-hdmi.yaml#
This is odd... With this plus the amount of conditional schema, I think
this should be a new schema doc. Doesn't have to have a common
schema. You can let the 2nd user of this IP block do that. Though if you
have the Synopsys spec, then it would be good to use it and be sure the
binding corresponds to it.
Rob
More information about the linux-arm-kernel
mailing list