[PATCH v3 00/14] arm64: Support for running as a guest in Arm CCA
Steven Price
steven.price at arm.com
Wed Jun 5 02:29:52 PDT 2024
This series adds support for running Linux in a protected VM under the
Arm Confidential Compute Architecture (CCA). This has been updated
following the feedback from the v2 posting[1]. Thanks for the feedback!
Individual patches have a change log for v3.
The biggest change from v2 is fixing set_memory_{en,de}crypted() to
perform a break-before-make sequence. Note that only the virtual address
supplied is flipped between shared and protected, so if e.g. a vmalloc()
address is passed the linear map will still point to the (now invalid)
previous IPA. Attempts to access the wrong address may trigger a
Synchronous External Abort. However any code which attempts to access
the 'encrypted' alias after set_memory_decrypted() is already likely to
be broken on platforms that implement memory encryption, so I don't
expect problems.
The ABI to the RMM from a realm (the RSI) is based on the final RMM v1.0
(EAC 5) specification[2]. Future RMM specifications will be backwards
compatible so a guest using the v1.0 specification (i.e. this series)
will be able to run on future versions of the RMM without modification.
Arm plans to set up a CI system to perform at a minimum boot testing of
Linux as a guest within a realm.
This series is based on v6.10-rc1. It is also available as a git
repository:
https://gitlab.arm.com/linux-arm/linux-cca cca-guest/v3
This series (the guest side) should be in a good state so please review
with the intention that this could be merged soon. The host side (KVM
changes) is likely to require some more iteration and I'll post that as
a separate series shortly - note that there is no tie between the series
(i.e. you can mix and match v2 and v3 postings of the host and guest).
Introduction (unchanged from v2 posting)
============
A more general introduction to Arm CCA is available on the Arm
website[3], and links to the other components involved are available in
the overall cover letter.
Arm Confidential Compute Architecture adds two new 'worlds' to the
architecture: Root and Realm. A new software component known as the RMM
(Realm Management Monitor) runs in Realm EL2 and is trusted by both the
Normal World and VMs running within Realms. This enables mutual
distrust between the Realm VMs and the Normal World.
Virtual machines running within a Realm can decide on a (4k)
page-by-page granularity whether to share a page with the (Normal World)
host or to keep it private (protected). This protection is provided by
the hardware and attempts to access a page which isn't shared by the
Normal World will trigger a Granule Protection Fault.
Realm VMs can communicate with the RMM via another SMC interface known
as RSI (Realm Services Interface). This series adds wrappers for the
full set of RSI commands and uses them to manage the Realm IPA State
(RIPAS) and to discover the configuration of the realm.
The VM running within the Realm needs to ensure that memory that is
going to use is marked as 'RIPAS_RAM' (i.e. protected memory accessible
only to the guest). This could be provided by the VMM (and subject to
measurement to ensure it is setup correctly) or the VM can set it
itself. This series includes a patch which will iterate over all
described RAM and set the RIPAS. This is a relatively cheap operation,
and doesn't require memory donation from the host. Instead, memory can
be dynamically provided by the host on fault. An alternative would be to
update booting.rst and state this as a requirement, but this would
reduce the flexibility of the VMM to manage the available memory to the
guest (as the initial RIPAS state is part of the guest's measurement).
Within the Realm the most-significant active bit of the IPA is used to
select whether the access is to protected memory or to memory shared
with the host. This series treats this bit as if it is attribute bit in
the page tables and will modify it when sharing/unsharing memory with
the host.
This top bit usage also necessitates that the IPA width is made more
dynamic in the guest. The VMM will choose a width (and therefore which
bit controls the shared flag) and the guest must be able to identify
this bit to mask it out when necessary. PHYS_MASK_SHIFT/PHYS_MASK are
therefore made dynamic.
To allow virtio to communicate with the host the shared buffers must be
placed in memory which has this top IPA bit set. This is achieved by
implementing the set_memory_{encrypted,decrypted} APIs for arm64 and
forcing the use of bounce buffers. For now all device access is
considered to required the memory to be shared, at this stage there is
no support for real devices to be assigned to a realm guest - obviously
if device assignment is added this will have to change.
Finally the GIC is (largely) emulated by the (untrusted) host. The RMM
provides some management (including register save/restore) but the
ITS buffers must be placed into shared memory for the host to emulate.
There is likely to be future work to harden the GIC driver against a
malicious host (along with any other drivers used within a Realm guest).
[1] https://lore.kernel.org/r/20240412084213.1733764-1-steven.price%40arm.com
[2] https://developer.arm.com/documentation/den0137/1-0eac5/
[3] https://www.arm.com/architecture/security-features/arm-confidential-compute-architecture
Sami Mujawar (2):
arm64: rsi: Interfaces to query attestation token
virt: arm-cca-guest: TSM_REPORT support for realms
Steven Price (5):
arm64: realm: Query IPA size from the RMM
arm64: Mark all I/O as non-secure shared
arm64: Make the PHYS_MASK_SHIFT dynamic
arm64: Enforce bounce buffers for realm DMA
arm64: realm: Support nonsecure ITS emulation shared
Suzuki K Poulose (7):
arm64: rsi: Add RSI definitions
arm64: Detect if in a realm and set RIPAS RAM
fixmap: Allow architecture overriding set_fixmap_io
arm64: Override set_fixmap_io
arm64: Enable memory encrypt for Realms
arm64: Force device mappings to be non-secure shared
efi: arm64: Map Device with Prot Shared
arch/arm64/Kconfig | 3 +
arch/arm64/include/asm/fixmap.h | 4 +-
arch/arm64/include/asm/io.h | 6 +-
arch/arm64/include/asm/mem_encrypt.h | 17 ++
arch/arm64/include/asm/pgtable-hwdef.h | 6 -
arch/arm64/include/asm/pgtable-prot.h | 3 +
arch/arm64/include/asm/pgtable.h | 7 +-
arch/arm64/include/asm/rsi.h | 48 ++++
arch/arm64/include/asm/rsi_cmds.h | 143 ++++++++++++
arch/arm64/include/asm/rsi_smc.h | 142 ++++++++++++
arch/arm64/include/asm/set_memory.h | 3 +
arch/arm64/kernel/Makefile | 3 +-
arch/arm64/kernel/efi.c | 2 +-
arch/arm64/kernel/rsi.c | 96 ++++++++
arch/arm64/kernel/setup.c | 8 +
arch/arm64/mm/init.c | 10 +-
arch/arm64/mm/mmu.c | 13 ++
arch/arm64/mm/pageattr.c | 65 +++++-
drivers/irqchip/irq-gic-v3-its.c | 90 ++++++--
drivers/virt/coco/Kconfig | 2 +
drivers/virt/coco/Makefile | 1 +
drivers/virt/coco/arm-cca-guest/Kconfig | 11 +
drivers/virt/coco/arm-cca-guest/Makefile | 2 +
.../virt/coco/arm-cca-guest/arm-cca-guest.c | 211 ++++++++++++++++++
include/asm-generic/fixmap.h | 2 +
25 files changed, 858 insertions(+), 40 deletions(-)
create mode 100644 arch/arm64/include/asm/mem_encrypt.h
create mode 100644 arch/arm64/include/asm/rsi.h
create mode 100644 arch/arm64/include/asm/rsi_cmds.h
create mode 100644 arch/arm64/include/asm/rsi_smc.h
create mode 100644 arch/arm64/kernel/rsi.c
create mode 100644 drivers/virt/coco/arm-cca-guest/Kconfig
create mode 100644 drivers/virt/coco/arm-cca-guest/Makefile
create mode 100644 drivers/virt/coco/arm-cca-guest/arm-cca-guest.c
--
2.34.1
More information about the linux-arm-kernel
mailing list