[PATCH v4 04/12] PCI: brcmstb: Use bridge reset if available

[Manivannan Sadhasivam]

On Tue, Jul 16, 2024 at 05:31:19PM -0400, Jim Quinlan wrote:
> The 7712 SOC has a bridge reset which can be described in the device tree.
> If it is present, use it. Otherwise, continue to use the legacy method to
> reset the bridge.
> 
> Signed-off-by: Jim Quinlan <james.quinlan at broadcom.com>
> Reviewed-by: Stanimir Varbanov <svarbanov at suse.de>
> Reviewed-by: Florian Fainelli <florian.fainelli at broadcom.com>
> ---
>  drivers/pci/controller/pcie-brcmstb.c | 22 +++++++++++++++++-----
>  1 file changed, 17 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/pci/controller/pcie-brcmstb.c b/drivers/pci/controller/pcie-brcmstb.c
> index c257434edc08..92816d8d215a 100644
> --- a/drivers/pci/controller/pcie-brcmstb.c
> +++ b/drivers/pci/controller/pcie-brcmstb.c
> @@ -265,6 +265,7 @@ struct brcm_pcie {
>  	enum pcie_type		type;
>  	struct reset_control	*rescal;
>  	struct reset_control	*perst_reset;
> +	struct reset_control	*bridge;

'bridge' is an opaque name. Use something like 'bridge_reset'.

>  	int			num_memc;
>  	u64			memc_size[PCIE_BRCM_MAX_MEMC];
>  	u32			hw_rev;
> @@ -732,12 +733,19 @@ static void __iomem *brcm7425_pcie_map_bus(struct pci_bus *bus,
>  
>  static void brcm_pcie_bridge_sw_init_set_generic(struct brcm_pcie *pcie, u32 val)
>  {
> -	u32 tmp, mask =  RGR1_SW_INIT_1_INIT_GENERIC_MASK;
> -	u32 shift = RGR1_SW_INIT_1_INIT_GENERIC_SHIFT;
> +	if (pcie->bridge) {
> +		if (val)
> +			reset_control_assert(pcie->bridge);
> +		else
> +			reset_control_deassert(pcie->bridge);

Well, these APIs will bail out if the reset_control pointer is NULL. So you can
just call them directly instead of if..else condition.

- Mani

-- 
மணிவண்ணன் சதாசிவம்