[PATCH v2 1/3] dt-bindings: net: bluetooth: Add support for Amlogic Bluetooth

[Krzysztof Kozlowski]

On 22/07/2024 09:41, Yang Li wrote:
>>>>> +    description: bluetooth chip 3.3V supply regulator handle
>>>>> +
>>>>> +  clocks:
>>>>> +    maxItems: 1
>>>>> +    description: clock provided to the controller (32.768KHz)
>>>>> +
>>>>> +  antenna-number:
>>>>> +    default: 1
>>>>> +    description: device supports up to two antennas
>>>> Keep it consistent - either descriptions are the last property or
>>>> somewhere else. Usually the last.
>>>>
>>>>> +    $ref: /schemas/types.yaml#/definitions/uint32
>>>> And what does it mean? What happens if BT uses antenna number 2, not 1?
>>>> What is connected to the other antenna? It really feels useless to say
>>>> which antenna is connected to hardware.
>>> Sorry, the antenna description was incorrect, it should specify whether
>>>
>>> Bluetooth and WiFi coexist. I will change it as below:
>>>
>>>       aml,work-mode:
>>>       type: boolean
>>>       description: specifywhether Bluetooth and WiFi coexist.
>> So one device can be used on different boards - some without WiFi
>> antenna? But, why in the binding of bluetooth you describe whether there
>> is WiFi antenna?
> 
> Yes, it can be used on dirfferent boards. The device can operate in both 

Please do not respond to only partial part of the comment. It is obvious
device can work on different boards. You do not have to confirm it. The
question was different - why do you need this property? I gave you
possible answer, but you skipped this and answered with obvious statement.

> standalone mode and coexistence mode. typically running standalone mode.
> 
> Therefore, I would like to revise the description as follows:
> 
> aml,coexisting:
>      type: boolean
>      description: Enable coexistence mode, allowing shared antenna usage 
> with Wi-Fi.

Why this is not enabled always?

Best regards,
Krzysztof