[PATCH v2 3/3] arm64: dts: rockchip: fix the pcie refclock oscillator on Rock 5 ITX

[Anand Moon]

Hi Dragan,

On Thu, 18 Jul 2024 at 13:02, Dragan Simic <dsimic at manjaro.org> wrote:
>
> Hello Anand,
>
> On 2024-07-18 09:26, Anand Moon wrote:
> > On Mon, 15 Jul 2024 at 16:35, Heiko Stuebner <heiko at sntech.de> wrote:
> >>
> >> The Rock 5 ITX uses two PCIe controllers to drive both a M.2 slot and
> >> its
> >> SATA controller with 2 lanes each. The supply for the refclk
> >> oscillator is
> >> the same that supplies the M.2 slot, but the SATA controller port is
> >> supplied by a different rail.
> >>
> >> This leads to the effect that if the PCIe30x4 controller for the M.2
> >> probes first, everything works normally. But if the PCIe30x2
> >> controller
> >> that is connected to the SATA controller probes first, it will hang on
> >> the first DBI read as nothing will have enabled the refclock before.
> >
> > I just checked the rk3588-rock-5-itx.dts in the linux-next.
> > You have not enabled sata0 and sata2, which might be the problem
> > for the SATA controller not getting initialized.
>
> Rock 5 ITX doesn't use RK5588's built-in SATA interfaces, so that's
> fine.
> Please have a look at the board schematic, it uses a separate PCI
> Express
> SATA controller for its four SATA ports.
>
yes, But I am referring to sata node not enabled which enable the PHY_TYPE_SATA.

see rk3588-coolpi-cm5-evb.dts and rk3588-edgeble-neu6a-io.dtsi
rk3588-quartzpro64.dts
which have sata port on board.

&sata0 {
        status = "okay";
};

Thanks
-Anand